|
Who's Online
There currently are 5629 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Even if the PDF is a scan, I can read the information I need.
The price is affordable and the service (mail sending) is very fast.
Thanks ! Regards. William (Fan of Kenwood)
;
Very good quality original datasheet!I like this amazing website!!!!!!
;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
FM Stereo Separation Adjustment Setting: [SOURCE] button : FM FREQUENCY SELECT switch : FM 200 k
FM RF signal generator antenna jack (J1) 0.01 µF set 10 k� + � level meter
MW Auto Scan/Stop Level Adjustment Setting: [SOURCE]and[MODE]buttons : MW FREQUENCY SELECT switch : MW 10 k
30 � 15 pF
65 pF
AM RF signal generator AM dummy antenna (50 �) Carrier frequency : 1000 kHz 30% amplitude modulation by 1 kHz signal Output level : 33 dB (44.7 µV)
Carrier frequency Output level Mode Modulation
AUDIO OUT REAR jack : 97.9 MHz (CNJ151) : 70 dB (3.2 mV) : stereo : main: 1 kHz, 33.75 kHz deviation (45%) sub: 1 kHz, 33.75 kHz deviation (45%) 19 kHz pilot: 7.5 kHz deviation (10%)
set
antenna jack (J1)
Procedure:
FM Stereo signal generator output channel L-CH R-CH R-CH L-CH L-CH L-CH R-CH R-CH A B Adjust RV4 on TU1 for minimum reading. C D Adjust RV4 on TU1 for minimum reading. Level meter connection Level meter reading (dB)
Procedure: 1. Set to the test mode. (See page 13) 2. Push the[SOURCE]button and set to FM. 3. Push the[MODE]button and set to MW. Display
L-CH Stereo separation: A-B R-CH Stereo separation: C-D The separations of both channels should be equal. Specification: Separation more than 30 dB Adjustment Location: See page 16.
TP
SHUF
4. Adjust with the volume RV1 on TU1 so that the �MW� indication turns to �MW0� indication on the display window. But, in case of already indicated �MW0�, turn the RV1 so that put out light �0� indication and adjustment. Display
TP
SHUF
Adjustment Location: See page 16.
� 15 �
|
|
|
> |
|