|
Who's Online
There currently are 5308 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
El producto satisface las necesidades del servicio t
;
This is a good quality scan of the Operation & Maintenance (Service) Manual for the PAL version of this high-band broadcast umatic, BVU-800P
All schematics and lineup procedures appear to be included in this one manual AFAICT.
The file size is just over 113 MB which gives an idea of the quality and number of pages.
All of the schematics, which contain some fairly small print, are easily readable when you zoom into the page.
John Thompson, Newcastle Upon Tyne, England.
;
Good quality, all schematics of few of models. There is also short form of user manual and regulation manual.
;
Perfect copy of the service manual. you can enlarge every page, and it comes up
with all details.
;
It´s very very nice manual with all, what i need. Original in good quality. Very fast business. Very much thanks...
FM Stereo Separation Adjustment Setting: [SOURCE] button : FM FREQUENCY SELECT switch : FM 200 k
FM RF signal generator antenna jack (J1) 0.01 µF set 10 k� + � level meter
MW Auto Scan/Stop Level Adjustment Setting: [SOURCE]and[MODE]buttons : MW FREQUENCY SELECT switch : MW 10 k
30 � 15 pF
65 pF
AM RF signal generator AM dummy antenna (50 �) Carrier frequency : 1000 kHz 30% amplitude modulation by 1 kHz signal Output level : 33 dB (44.7 µV)
Carrier frequency Output level Mode Modulation
AUDIO OUT REAR jack : 97.9 MHz (CNJ151) : 70 dB (3.2 mV) : stereo : main: 1 kHz, 33.75 kHz deviation (45%) sub: 1 kHz, 33.75 kHz deviation (45%) 19 kHz pilot: 7.5 kHz deviation (10%)
set
antenna jack (J1)
Procedure:
FM Stereo signal generator output channel L-CH R-CH R-CH L-CH L-CH L-CH R-CH R-CH A B Adjust RV4 on TU1 for minimum reading. C D Adjust RV4 on TU1 for minimum reading. Level meter connection Level meter reading (dB)
Procedure: 1. Set to the test mode. (See page 13) 2. Push the[SOURCE]button and set to FM. 3. Push the[MODE]button and set to MW. Display
L-CH Stereo separation: A-B R-CH Stereo separation: C-D The separations of both channels should be equal. Specification: Separation more than 30 dB Adjustment Location: See page 16.
TP
SHUF
4. Adjust with the volume RV1 on TU1 so that the �MW� indication turns to �MW0� indication on the display window. But, in case of already indicated �MW0�, turn the RV1 so that put out light �0� indication and adjustment. Display
TP
SHUF
Adjustment Location: See page 16.
� 15 �
|
|
|
> |
|