There are currently no product reviews.
This is a great and complete Service Manual for the Sharp GF8585HB. Giving full and detailed technical insight. Good to find these manuals online.
Everything was ok with the manual. If I have a small complaint, is that I ordered it during the weekend and I think you guys were closed. But I did receive it late Sunday. I will surely order from you again
Best Service! Very fast and easy to handle. Fast Download an you can come back every day to download again
Very good quality, no parts are missing and everthing is readable.
Thank you very much. :-)
This manual is all I need to check and repair my equipment. Thank you....
SECTION 5 MECHANICAL ADJUSTMENTS
1. Clean the following parts with a denatured-alcohol-moistened swab: playback head pinch roller rubber belt capstan idlers 2. Demagnetize the playback head with a head demagnetizer. 3. Do not use a magnetized screwdriver for the adjustments. 4. After the adjustments, apply suitable locking compound to the parts adjusted. 5. The adjustments should be performed with the power supply voltage unless otherwise noted. â¢ Torque Measurement
Mode Forward Forward Back Tension Reverse Reverse Back Tension FF, REW CQ-102RC Torque Meter CQ-102C Meter Reading 2.95 â 6.37 Nâ¢m 30 â 65 gâ¢cm (0.42 â 0.90 ozâ¢inch) 0.05 â 0.44 Nâ¢m 0.5 â 4.5 gâ¢cm (0.01 â 0.06 ozâ¢inch) 2.95 â 6.37 Nâ¢m 30 â 65 gâ¢cm (0.42 â 0.90 ozâ¢inch) 0.05 â 0.44 Nâ¢m 0.5 â 4.5 gâ¢cm (0.01 - 0.06 ozâ¢inch) 5.89 â 19.61 Nâ¢m 60 â 200 gâ¢cm (0.83 â 2.78 ozâ¢inch)
SECTION 6 ELECTRICAL ADJUSTMENTS
6-1. TEST MODE <Set the Test Mode> 1. Set the âOFFâ mode. 2. Push the preset  button. 3. Push the preset  button. 4. Press the preset  button for more than two seconds. 5. Then the display indicates all lights, the test mode is set. <Release the Test mode> 1. Push the [OFF] button. Adjustment Location:
â SET UPPER VIEW â
Tape Speed Adjustment
TAPE DECK SECTION
Tape Speed Adjustment Setting:
0 dB=0.775 V
speed checker or frequency counter test tape WS-48A (3 kHz, 0 dB) set 10 kâ¦
AUDIO OUT jack (J331)
Procedure: 1. Put the set into the FWD PB mode. 2. Adjust adjustment resistor for inside capstan motor so that the reading on the speed checker or frequency counter becomes in specification. Specification: Constant speed
Speed checker â1.5 to +2.5% Frequency counter 2,955 to 3,075 Hz
â¢ Tape Tension Measurement
Mode Forward Tension Meter CQ-403A Meter Reading more than 0.88 N more than 90 g (more than 3.18 oz) more than 0.88 N more than 90 g (more than 3.18 oz)
0 dB=1 ÂµV
The tuner section has no adjustment.