|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
- GENERAL
- Location of Controls
- Setting the Clock
- Labelling the Rotary Commander
- Using the Rotary Commander
- Installation
- Connection
- DISASSEMBLY
- ASSEMBLY OF MECHANISM DECK
- MECHANICAL ADJUSTMENTS
- ELECTRICAL ADJUSTMENTS
- Test Mode
- Tape Deck Section
- Tuner Section
- DIAGRAMS
- Printed Wiring Boards - Main Section - (Side A)
- Printed Wiring Boards - Main Section - (Side B)
- Schematic Diagram - Main (1/2) Section
- Schematic Diagram - Main (2/2) Section
- Printed Wiring Board - Panel Section (Side A), (Side B)
- Schematic Diagram - Panel Section
- IC Pin Function Description
- EXPLODED VIEWS
- ELECTRICAL PARTS LIST
There are currently no product reviews.
;
I was very glad recieving the service manal from You. Additionaly very fast. Extremaly nice servicing. Thanks very mach! Now my GX-220 working better, than it was made. Alexander from Moscow, Russia/
;
Sweet! I won the item on eBay and couldn't adjust the geometry or even keep a steady picure. This guide has the full schematics (not available anywhere else as far as I could tell), and was a bargain for the wealth of knowledge it contains. I hooked it up to my testing equipment, tweaked a few potentiometers and got it playing videogames in no time. Thanks!
;
It was just what I need to fix my old BMW's CD player. Very convenient also. Thank you.
;
Great Manual! It contains all the wiring schematics and mechanical exploded views that are essential for service and repair. I was surprised I even found this for such an old machine. Only wish I knew of this site many years ago.
;
Great manual very clear copied. You are making an incredible job. I appreciate a lot the rapidity and your efficiency. Thanks a lot
SECTION 3 ASSEMBLY OF MECHANISM DECK
Note: Follow the assembly procedure in the numerical order given.
HOUSING
5 Fit projection on C part. 2 Install the hanger onto two claws of the housing. 4 Fit claw on B part.
7 Holder the hanger by bending the claw. 1 Install the catch to the hanger.
hanger
3 Put the housing under A part.
6 Fit projection on D part.
housing
C part 8 Hold the hanger by bending the claw.
D part
A part
B part
ARM (SUCTION)
2 Move the arm (suction) in the arrow direction and fit on projection.
projection
1 Fit the arm (suction) on the shaft.
� 10 �
|
|
|
> |
|