|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
The AKAI 1720 model reel to reel tape recorder described in this Manual is quite an old unit - circa late 1960's. As a consequence, the description of the mechanical details - and adjustments thereof - is quite critical. The manual does this quite well. The schematics are also well presented and have detailed PCB overlays. Probably the only negative is that some half-tone detail has been lost from the original manual as it has been scanned in simple B&W.
;
Perfect source for service manuals: fast and professional transaction; high quality, perfect readable and largely scaleable PDF; complete schemes, diagrams and spare part list. Tnx a lot, cu again!!!!
;
I got your link from a friend and I must say that I am really satisfied with your service. Specially this B&O manual I didn't find anywhere on the web... but you could deliver it :-) . You deliver very fast and the copy is of good quality. So your webpage is bookmarked. Thanks
;
This was the Sony CCU-500A Service manual I was looking for.
The price was reasonable.
The permission to download was quck.
I will use Owner-Manual.com for all my manual needs.
;
Excellent printing quality.
A complete and very usefull service manual with all details.
GREAT SERVICE AT VERY LOW PRICE!
A+++++++++++++++++++++++++
XM-4060GTX SECTION 3 ELECTRICAL ADJUSTMENT
Bias Adjustment
Note : The Bias adjustment should be performed only if any of Q109 and Q110 for RV104, Q209 and Q210 for RV204, Q309 and Q310 for RV304, and Q409 and Q410 for RV404 are replaced. Setting :
stabilized power supply digital voltmeter
B+, REM terminals
set
+ _
GND terminal
test points
Procedure: 1. Rotate variable resistors RV104 (FRONT L-CH), RV204 (FRONT R-CH), RV304 (REAR L-CH) and RV404 (REAR R-CH) full clockwise as seen from the pattern side to minimize the bias current. 2. The input signal is with no signal. 3. Connect the stabilized power supply between B+ and REM terminals and gradually increase the voltage to 14.4 V while checking for any abnormal current. 4. Adjust RV104 (FRONT L-CH), RV204 (FRONT R-CH), RV304 (REAR L-CH) and RV404 (REAR R-CH) so that the digital voltmeter connected between the respective test points reads 6±1 mV. RV Ref. No. RV104 RV204 RV304 RV404 Test points TP11 and TP12 TP21 and TP22 TP31 and TP32 TP41 and TP42
5. After this adjustment, verify that the current value of the stabilized power supply is 1.4 to 1.8 A. Adjustment Location :
� MAIN BOARD (CONDUCTOR SIDE) � RV304 BIAS ADJUSTMENT (REAR L-CH) TP41 TP31TP32 TP42 TP12 RV404 BIAS ADJUSTMENT (REAR R-CH) TP11 RV104 BIAS ADJUSTMENT (FRONT L-CH) TP21 RV204 BIAS ADJUSTMENT (FRONT R-CH) TP22
9
|
|
|
> |
|