Excellent printing quality.
A complete and very usefull service manual with all details.
GREAT SERVICE AT VERY LOW PRICE!
The manual is an excellent reproduction with complete schematics, made troubleshooting and repair a simple process.
Up to now you are the BEST! Prompt-efficient and so reasonable ! I have been after SONY service manual for quite some time !Thank you very much ! I can recomend your service to
all my collegagues ! V.Bergfield .
This is a very good quality print (scan) of the original SONY service manual. The original from Sony is on very thin paper. Nevertheless it is very clear and sharp and excellent readable. I'm very satisfied to have now this rare document. I've looking for it many years (infrequent). It contains very detailed circuit diagrams, exploded views, part lists, PCB view with good readable connection lines. Very recommended.
A complete manual with all the needed details of calibrations and service instructions about the radio receiver.
A big deal.
Many thanks !
Fast delivery and good quality copy. To be recommended
Example: when the group 00 is selected for CE62 model
3 Once the desired channel number appears, set the
POWER switch to OFF to release Setting mode. Or, press the SET button to continue operations in Setting mode. The next time you turn on the power only by setting the POWER switch to ON, the transmitter will be set to Transmit mode with the selected channel.
the station's channel. â¢ The unit may not operate correctly if it is turned on again immediately after turning off the power while in setting mode. Pause for a few seconds or more before turning on the power again. â¢ When operating two or more UHF wireless microphone systems using channels in different groups, ensure that the systems are at least 100 m (330 feet) apart from each other. (The same applies also when using channels in a group if the different UHF wireless microphone systems are installed where they are within sight of each other.)
â¢ The unit cannot transmit in Setting mode. â¢ Make sure that the channel selected is the same as that selected on the tuner used in the same system. â¢ Depending on the noise or interference conditions, the selectable channels may not necessarily all be usable. If necessary, you can determine the usable channels by stepping the channel selection through a number of channels on the tuner with the microphone/transmitter set to OFF. Those channels on which the RF indicator of the tuner does not light are usable. â¢ If there is a TV broadcasting station near by, do not use
Settings Changing the Input Attenuation Setting
You can change the input attenuation setting in 3-dB steps in a range of 0 to 21 dB. You can change it either in Setting mode or in Transmit mode. Changing in Setting mode The next time you turn on the power only by setting the POWER switch to ON, the transmitter will be set to Transmit mode with the selected attenuation setting. Changing in Transmit mode You can also change the input attenuation level during transmission.
1 Set the unit in Setting mode. 2 Press the SET button until the attenuation level indication
appears on the display.
Attenuation level indication
1 If the attenuation level is not displayed, press the SET
button until the attenuation level indication appears on the display.
2 Press the + or â button to select the level.
Resetting the Accumulated Time Indication
3 Press the + or â button to select the attenuation level.
If you keep either button pressed, the level will be incremented or decremented successively.
The time indication accumulates time in hours and minutes when the WRT-822A is on. Reset the indication to â00:00â whenever you replace the batteries so that it can display the running time of the batteries.
4 Once the desired level appears, set the POWER switch to
OFF to release Setting mode. Or, press the SET button to continue operations in Setting mode.
1 Set the unit in Setting mode. 2 Press the SET button until the accumulated time
indication appears on the display.