|
Who's Online
There currently are 6040 guests and 3 members online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Hard to find manual was ready the next day. Scans were very legible (including schematics). All the essential parts of the service manual were present (adjustment procedure, schematics, and parts list). It would have been nice if the rest of the manual was included (disassembly procedure, theory of operation, etc.).
;
The Service Manual for the Kenwood KR-V55R provided by owner-manuals.com was as described/advertised. The contents provided the necessary information to effect a diagnosis of the unit. The schematics above all else was instrumental in tracing the the signal flow from component to component.
;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
;
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
;
The manual is of better quality compared to other. I found it less expensive and therefore it it is the best buy cost vs quality.
WM-FX888 SECTION 4 MECHANICAL ADJUSTMENTS
PRECAUTION 1. Clean the following parts with a denatured-alcohol-moistened swab: playback head pinch roller rubber belts capstan 2. Demagnetize the playback head with a head demagnetizer. (Do not bring the head demagnetizer close to the erase head.) 3. Do not use a magnetized screwdriver for the adjustments. 4. The adjustments should be performed with the rated power supply voltage (1.3 V) unless otherwise noted. Torque Measurement
Mode FWD CQ-102C FWD Back Tension Torque Meter Meter Reading (1.47 � 2.94 mN�m) 15 � 25 g�cm (0.22 � 0.36 oz�inch) (0.029 � 0.196 mN�m) 0.3 � 2.0 g�cm (0.004 � 0.01 oz�inch) (1.47 � 2.94 mN�m) 15 � 25 g�cm (0.22 � 0.36 oz�inch) (0.029 � 0.196 mN�m) 0.3 � 2.0 g�cm (0.004 � 0.01 oz�inch) (more than 3.43 mN�m) more than 35 g�cm (more than 0.5 oz�inch) Type WS-48A Signal 3 kHz, 0 dB Used for Tape Speed Adjustment
SECTION 5 ELECTRICAL ADJUSTMENTS
PRECAUTION 1. Specified voltage : 1.3 V (DC) 2. Setting SOUND RV/MB/GRV : OFF AVLS : OFF ;NR : OFF BL SKIP : OFF
TAPE DECK SECTION
Test tape
0 dB=0.775 V
Tape Speed Adjustment Setting: Function: TAPE
Test tape WS-48A (3 kHz, 0 dB) 16 � frequency counter
REV CQ-102RC REV Back Tension FF, REW CQ-201B
set
+ �
i jack (J701)
Procedure: 1. Playback WS-48A (tape center) in the FWD state. 2. Adjsut RV601 so that the frequency counter reading becomes 3,000 Hz. Specification Values: 2,970 to 3,030 Hz 3. Playback WS-48A (tape center) in the REV state. Check that the frequency counter reading is within 2% (approx.60 Hz) of the reading of step 1. Adjustment Location: MAIN BOARD (See page 12)
11
|
|
|
> |
|