There are currently no product reviews.
have download a number of manuals todate , most are excellant, one or two sometimes a little difficult to read but a least avaialable, great site .
Excellent had everything I wanted, very happy with purchase
This service is relatively cheap, document is fast available, schematic is readable.
So far Iยดm a satisfied customer. I have only downloaded "TECHNICS SX-KN470 Service Manual" maybe I will use it later.
Good manual. It is complete and of high quality, both text and graphics. The schematics are with the original big size, so it can be viewed or printed without any loss of resulution and sharpness.
SECTION 3 ADJUSTMENTS
3-1. MECHANICAL ADJUSTMENTS
3-2. ELECTRICAL ADJUSTMENTS
1. Clean the following parts with a denatured-alcohol-moistened swab : playback head pinch roller capstan rubber belt 2. Demagnetize the playback head with a head demagnetizer. Do not use a magnetized screwdriver for the adjustments. 3. These measurement and adjustment should be performed with the rated power supply voltage (2.5 V) unless otherwise noted. Torque Measurement
Mode FWD FWD back tension REV (FX467/FX467ST) REV back tension (FX467/FX467ST) FF, REW CQ-201B CQ-102C Torque meter Meter reading 20 â 42 g â¢ cm (0.28 â 0.58 ozâ¢ inch) less than 2 g â¢ cm (less than 0.027 ozâ¢ inch) 20 â 42 g â¢ cm (0.28 â 0.58 ozâ¢ inch) less than 2 g â¢ cm (less than 0.027 ozâ¢ inch) more than 60 g â¢ cm (more than 0.84 ozâ¢ inch)
â¢ Supplied voltage : 2.5V. â¢ Switch and control position MEGA BASS : OFF VOLUME control : maximum AVLS : NORM
0 dB = 0.775V
Signal 3kHz, 0dB
Used for Tape Speed Adjustment
Tape Speed Adjustment Procedure :
test tape WS-48A (3kHz, 0dB) set
frequency counter 32 â¦
phones jack (J301)
(FX277) 1. Playback WS-48A (tape center part) and adjust RV601 so that the frequency counter reading becomes 3,000Hz. Standard value : 2,985â3,015Hz 2. Playback WS-48A (tape top and end) . Check that frequency counter reading is within Â±1.0% of the reading of step 1. (FX467/FX467ST) 1. Playback WS-48A (tape center part) in the FWD state and adjust RV601 so that the frequency counter reading becomes 3,000Hz. Standard value : 2,985â3,015Hz 2. Playback WS-48A (tape center part) in the REV state. Check that frequency counter reading is within Â±1.0% of the reading of step 1. Adjustment Location :
RV601 : Tape speed Adjustment