There are currently no product reviews.
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
Wow very wonderful and clear!!!! I will always trust them
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Great Job!!! clear and efficient as always!!
it is really nice to have peple that are doing such a good work!!!!!
TA-S3 SECTION 1 SERVICING NOTES
This set is a component of the MHC-S3. The MHC-S3 system configuration is as shown below, and therefore it does not operate normally unless all four components are connected. In performing the repair, connect all components with the system cables.
Note: The precaution to the users is described on the label stuck on the back panel (CD player) and in the troubleshooting section in the Operation Manual.
SYSTEM & CD Âµcon DISPLAY
FRONT AMP BOARD SERVICE POSITION In checking the FRONT AMP board, prepare jig (extension cable J-2501-087-A: 1.25 mm Pitch, 23 core, Length 300 mm) (Fig A)
Turn over the FRONT AMP board with Heat Sink, THP board and RELAY board connected.
Remove the back panel (2CD/VCD) section.
FRONT AMP board (CN104)
Connect jig (extension cable J-2501-087-A to the FRONT AMP board (CN104) and PANEL board (CN700).
PANEL board (CN700)
Remove the fan motor connector lead wire.