|
|
|
Who's Online
There currently are 5978 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
 ;
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
;
The manual is of better quality compared to other. I found it less expensive and therefore it it is the best buy cost vs quality.
;
I bought the service-manual of the sony ICB-1020(an old transmitter-receiver) at "www.Owners-Manual.com", I found the service-manual for a fairly cheap price(in comparison with other sellers). I filled in some questions, payed the order with Ideal, and within 24 hours I had my service manual. I was very happy:In no time I had my service-manual and everything, but literally everything was noted down in the manual; the electronic scheme, the parts list, etcetera.
A very practical, reference-document.
;
This comprehesive service maual was greatly appreciated, as was the digital download.
ST-SE370 SECTION 3 TEST MODE
NOTE : The preset data will be erased when this test mode is used. Therefore, take down the data before setting this mode and preset the data again after completing operations in this mode. 1. Display Tube and Key Check Mode 1-1. Display Tube Check 1-1-1. Turn OFF the power. 1-1-2. While pressing 1 and BAND together, turn ON POWER . 1-1-3. While continuously pressing 1 and BAND together, check the following. Microcomputer version indication (1 sec) t All light up (1) t 8-digit test pattern (2) t 2-digit test pattern (3)
T
(1) All light up
(2) 8-digit test pattern
(3) 2-digit test pattern
The display changes every 500 msec. 1-2. Key Check 1-2-1. Release 1 and BAND . The KEY CHECK mode will be set. 1-2-2. All key numbers will be displayed. Key Number : 23 1-2-3. Each time the key is pressed, the key number will be counted down. Each key will be counted only once, at the first time. 1-2-4. When all keys have been pressed, the process will end and the factory preset will be entered. 2. Entering the Factory Preset To skip �1. Display Tube Key Check Mode�, and factory preset : (1) Turn OFF the power. (2) While pressing 3 and BAND together, turn ON POWER . 3. Circuit Check Mode Set to the reception frequency that the circuit can receive (FM : STEREO, RDS stations). (Set the input level to above 70 dB.) This enables circuit check to be performed in any of the reception modes-FM, AM (MW, LW). Set to a desired band before setting the test mode. (1) Turn OFF the power. (2) While pressing 4 and BAND together, turn ON POWER . � The items in the following table will be checked automatically in order every 2 seconds.
Display TUNED IF SIG L ST RDS
Items
AST signal = LOW IF COUNT OK SI LEVEL = 70dB > ST signal = LOW RDS DATA OK
DISPLAY
FM RDS
OK or NG OK or NG OK or NG OK or NG OK or NG
AM (MW, LW) IC201 NG, RV201 adjustments OK or NG TB101, IC201 NG TB101 NG TB101 NG IC801 NG
NG
6
 $4.99 STSE370 SONY
Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|
