Very pleased with manual except that a few more details in the drawings might make the job (not yet done, tut-tut) easier. Should be adequate though. Actually I didn't have to pay for this anyway as I was given credit for another item that wasn't quite complete. Good service, then.
Hi - happy with what I received but not quite what I wanted - my fault I assumed that service manual would also include operational instructions which is what I needed - all I needed to know was how to turn the radio - thanks
Text excerpt from page 5 (click to view)
SECTION 3 ELECTRICAL ADJUSTMENTS
Precautions in Repairing Note. 1 : The adjustment should be performed in the publication. (AM nFM) Note. 2 : As a front-end (FE1) is difficult to repair if faulty, replace it with new one. AM SECTION AM Tuned Indication Lighting Level Setting : Band :AM ( MW)
loop antenna B loop antenna A AM RF signal generator FE1
set
Adjustment Location :
[ TCB BOARD ] � Component side �
RV41 : AM Tuned Indication Lighting Level
Carrier frequency : 999kHz
Procedure : 1. Set loop antenna A so that the loop antenna B input level becomes 55dBµ/m (0.6mV/m). 2. Tune the set to 999kHz . 3. Adjust RV41 so that the TUNED indicator goes on. FM SECTION FM Tuned Indication Lighting Level Note : Always make the tuning level adjustment first. (Since it affects the FM tuning level.) Setting : Band : FM
FM RF stereo signal generator FM ANTENNA terminal 75 � coaxial
RV42 : FM Tuned Indication Lighting Level
set
Carrier frequency : 98MHz Modulation : OFF Output level :0.018mV (25dBµ)
Procedure : 1. Tune the set to 98MHz. 2. Adjust RV42 so that the TUNED indicator goes on. Adjustment Location : TCB board
