|
|
|
Who's Online
There currently are 5955 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This site is working fine! Did buy a manual for SX-EX25L and after a while I could download it and fix the problem. Nice and easy!
 ;
Complete manual as pdf-file in very good quality. Very helpful and fast availability.
;
Complete service manual in very good scanning quality with all schematic and PWB graphics as well as assembly & maintenance instructions. A slight drawback is that the rastering of the PWB graphics sometimes makes it a bit difficult to follow fine traces, but no showstopper.
;
Purchased the manual that I was looking for at a great price and could download it easily.. Great service experience and for future purchases I plan to use the site. Thank you very much
;
Service manual in good quality, it was very helpful to me. Perfect service, I am very satisfied.
Jochen Kelm
No Tray open / close operation
Is the connector properly inserted into CN800 ? Y When pressing the EJECT SW, does the peak value of the IC400 5Pin become 3.3V? Y When it is in the Tray Open mode, does the IC400 6Pin show 1.65V?
N
Try the operation after inserting the connector to CN800 properly.
N
Check the SW701 patterns and the welding condition.Replace it if the condition is normal.
N
Check the SW701 Open and Close patterns and the welding condition. Replace it if the condition is normal. Y
CLOSE
Y
OPEN
When pressing the EJECT SW, does the IC500 Pin26 vary from 0V to the value between1.15V and 2.15V and then show 1.65V finally?
N
Check the condition and patterns of R615, R616. If they are normal, replace IC500.
N
When pressing the EJECT SW, does the IC500 26Pin vary from 1.65V to the value between 1.15V and 2.15V and then show 0V finally?
N
Y
Is the Tray Motor able to output the Pin49 and 50 of IC500? Y
Y
Replace TRAY MOTER.
18
|
|
|
> |
|
