|
Who's Online
There currently are 5473 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
The manual is well organized and is easy to read. The chapters are following normal way to proceed.
;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
;
Very useful service manual, was exactly what i needed.Good quality,reasonable price.Thank you.
;
Acurate informations inside the SM and I could repair my old Sansui SC-3330 without any problems. Thanks.
;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
SRF-HM01V SECTION 1 GENERAL
POWER ON/OFF Hang the hooks on your ears. Neckband Neckband Hook (L, R) Battery compartment lid
This section is extracted from instruction manual.
L (Left)
TV/WB/FM SENS DX/LOCAL Driver Unit
R (Right)
VOL*1 TUNE +*2/� Display Light reflector (R, L)
This reflector reflects car lights at night for your safety. *1 There is a tactile dot beside volume to show the direction to turn up the volume. *2 The TUNE + button has a tactile dot.
BAND
MEGA BASS/CLOCK ENTER
MODE
Setting the Clock
The clock time display of this unit is a 12-hour system. When the battery is first installed, �AM 12:00� flashes in the display.
Changing AM Channel Step
The AM channel step differs depending on areas. The channel step of this unit is factory-set to 10 kHz. Change the settings as shown below to be able to listen to the radio. Area North and South American countries Other countries Channel step 10 kHz 9 kHz
1 2
Set POWER to OFF to turn off the power. Hold down MEGA BASS/CLOCK for more than 2 seconds until �AM 12� starts flashing.
Note When the AM channel step is changed, only the preset stations on the AM band will be initialized.
3
Press TUNE + or � to adjust the hour, then press MEGA BASS/CLOCK.
If you hold down TUNE + or �, the digit changes rapidly. �AM 12:00 �= midnight, �PM 12:00 �= noon.
1 2
Set POWER to OFF to turn off the power. While holding down MODE, hold down TUNE + or � for more than 5 seconds.
The channel step will change and �9� kHz (or �10� kHz) will flash for 3 seconds in the display. If you proceed to step 2 again, the channel step changes again.
4
Repeat step 3 above to adjust the minute.
�:� starts flashing and the clock starts operating. To set the current time exactly to the second, adjust the minute and then press MEGA BASS/CLOCK to synchronize with a time signal (such as the telephone time signal).
Note If you do not press TUNE + or �, or MEGA BASS/CLOCK within one minute, the clock setting mode will be canceled.
3
|
|
|
> |
|