|
|
|
Who's Online
There currently are 5787 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
have download a number of manuals todate , most are excellant, one or two sometimes a little difficult to read but a least avaialable, great site .
Brad.
;
Excellent had everything I wanted, very happy with purchase
 ;
This service is relatively cheap, document is fast available, schematic is readable.
Thanks.
;
So far I´m a satisfied customer. I have only downloaded "TECHNICS SX-KN470 Service Manual" maybe I will use it later.
Best regards
Peter
;
Good manual. It is complete and of high quality, both text and graphics. The schematics are with the original big size, so it can be viewed or printed without any loss of resulution and sharpness.
2.
PERIODIC CHECK AND REPLACEMENT
In order to obtain the best performance from this unit and make full use of its capabilities, and to extend the life of the unit and tapes, it is recommended that the following periodic checks and maintenance be performed. * The following must be done after every repair regardless of how many hours the user has operated the machine.
2-1.
1)
CLEANING OF ROTATING HEAD DISK ASSEMBLY
2-2.
1)
CLEANING OF THE TAPE MOVEMENT SYSTEM
2)
Press a chamois cloth (Jig Ref. No. J-4) which has been dipped in cleaning fluid (Jig Ref. No. J-3) lightly against the rotating drum assembly, then do the cleaning by slowly rotating the rotating head disk by the hand. (Never try to clean by using the motor to turn it.) Never try to clean by moving the chamois cloth at a vertical angle to the head tip. There is a very great danger of damaging the head tip if this is done.
Clean the surfaces which the tape contacts during its movement (tape guide, drum assembly surface, capstan, pinch roller, etc.) with a chamois cloth that has been dipped in cleaning fluid.
2-3.
1)
CLEANING THE DRIVE SYSTEM
Clean the driving parts with a cloth that has been dipped in cleaning fluid.
TG4
TG5
TG6
ACE head
TG7
Capstan shaft
TG3
TG8
FE head TG2 TG1 Pinch roller
Fig. 2-1 Parts requiring cleaning
�8�
|
|
|
> |
|
