Another excellent buy! A fully readable PDF archive. Good prints!!
Text excerpt from page 59 (click to view)
5-3 HEAD SWITCHING POINT ADJUSTMENT
1) Playback the alignment tape. 2) Press the âTESTâ button on Main PCB/Function PCB to set the adjustment mode. (See Fig. 5-2 and 5-3) 3) Press the âSP/LPâ button of remote control then adjustment is operated automatically. (See Fig. 5-1) 4) Turn the Power off.
5-4 NVRAM OPTION SETTING
1) NVRAM Option is adjusted at production line basically. 2) In case Micom (IC601) and NVRAM (IC605 ; EEPROM) is replaced, be sure to set the corresponding option number of the reqaired model. (If the option is not set, the unit is not operated.) 1) Press the âTESTâ button on Main PCB/Function PCB to set the adjustment mode. (See Fig. 5-2 and 5-3) 2) Press the âMENUâ button on the remote control about 5 seconds then option setting display is appeared. (See Fig. 5-5 and 5-6) 3) Select the option number (See Table 5-1) of corresponding model with âFF/REW/STOP/PAUSEâ button on the remote control. 4) If selecting the option number is completed, press the âOK (PLAY)â button of remote control. (If âOK (PLAY)â button is pressed, the selected number is changes reversed color. ; See Fig. 5-5) 5) Press the âMENUâ button of remote control again to store the option number. (âPLEASE WAITâ is displayed for a second as shown Fig. 5-6 and this setting is completed.) 6) Turn the Power off.