|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
This manual is very helpful, correct shematic diagram, and good exploded view.Perfect!
;
Alte gescannte Servicepläne sind oft doch etwas undeutlich . Stromlaufpläne werden auf mehrere DIN A4 Seiten aufgeteilt. Alles ziemlich umständlich und zeitaufwendig. Aber mit etwas Mühe geht alles.
;
Great item, high resolution, detailed, very easy to work with.
;
fast delevery of the manual and very complete manual, now my Akai works again, will buy again, thanks.
;
Tartalma megfelelő. Szebb kivitelű is lehetne a scannelés.
SECTION 6 ADJUSTMENTS
6-1 MECHANICAL ADJUSTMENTS
For the mechanical adjustments, please refer to the �VHS MECHANICAL ADJUSTMENT MANUAL (S MECHANISM)� (9-921-647-11).
SLV-AX10/AX20/N50/N60/N70/N80/ LX4/LX5/LX6S/LX7S/LX8S
2-1-3. Set-up of Adjustment In this adjustment, NTSC pattern generator is connected with LINE input terminal. When check to tuner, connected AERIAL terminal. Check that the synchronizing signal of the Y signal has an amplitude of approximately 0.7 V and that the burst signal has an amplitude of approximately 0.3 V and its waveform is flat. And check that the level ratio of burst signal to �red� signal is 0.30 : 0.66. The video signal (color bar) used for electrical aligning this unit is shown in Fig. 6-2-2.
6-2. ELECTRICAL ADJUSTMENTS
See the adjusting part location diagram from on page 6-6 for the adjustment. 2-1. PREPARATION BEFORE ADJUSTMENT 2-1-1. Equipment Required The measuring instruments used for this alignment include: 1) Monitor TV 2) Oscilloscope, dual-trace, bandwidth of 30 MHz or more, with delay mode (A probe 10:1 should be used unless otherwise specified.) 3) Frequency counter 4) NTSC Pattern generator 5) 6) 7) 8) 9) 10) Remote commander Digital voltmeter Audio generator Audio level meter Audio attenuator Alignment tapes KRV-51N2 (NTSC) Part No. : 8-192-605-32
NTSC model
White (100%)
About 0.7 V About 0.3 V Red Horizontal sync signal Burst signal (It must be flat.)
About 0.3 V
Fig. 6-2-2 Color Bar Signals of Pattern Generator
2-1-4. Alignment Tape � Contents of KRV-51N2 Audio signal Mode Period 7 minutes 3 minutes 7 minutes 3 minutes Video signal Color bar Monoscope Color bar Monoscope Hi-Fi 400Hz (L/R) Normal 400Hz 1 2 3 4
2-1-2. Equipment Connection Unless otherwise specified, connect and adjust the measuring instruments as shown in the following diagram.
VIDEO LINE IN Pattern generator VCR Monitor TV
SP LP
Video output (75�)
VIDEO LINE OUT
Fig. 6-2-1
6-1
$4.99 SLVN70 SONY Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|