|
Who's Online
There currently are 5776 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Good condition and quality. Hard to find anywhere in Internet, only on this site.
;
Exactly what I needed to be able to bring the amp back to life... will come back to this site the next time I need schematics.
;
Information was accurate and very helpful.
However the continuity made it a little difficult to follow from one page to the next.
;
Very very good as usual very trustable site. Perfect!!!!!!
;
The Service Manual received was helpful. Good copy of original document.. I recomend all of my friends about this technical page.
5. Initialization (Differs according to destination) After executing the test mode, be sure to perform initialization. � For J/SP/AEP Version (Use this procedure) While pressing the AC-3 RF button and DIGITAL3 buttons simultaneously, press the POWER button. When the VOLUME LED starts blinking, release the buttons. �initialized (J/SP/AEP)� will be displayed on the fluorescent display tube, and all internal settings will be returned to the initial values. � For U/CA version (Do not use this procedure) While pressing the AC-3 RF button and DIGITAL4 buttons simultaneously, press the POWER button. When the VOLUME LED starts blinking, release the buttons. �initialized (U/CA)� will be displayed on the fluorescent display tube, and all internal settings will be returned to the initial values. NOTE: As all histories of abnormal DSP operations will be erased, note down the contents of the history beforehand. 6. Check of Pressing of Unintended Button � This check is always performed when the power is turned ON. Therefore when an error occurs, it can be known without setting the test mode because the VOLUME LED blinks and the fluorescent display tube stops displaying. � When an unintended button is pressed during the test mode or initialization, the VOLUME LED also blinks, and the fluorescent display tube stops displaying, preventing no mode to be set. 7. Other Functions In the personal use of the unit at home, if no sounds are produced due to DSP problems, the DSP will be rebooted automatically to attempt recovery. If no sounds are still produced after five retries, �Turn POWER SW off!� will be displayed on the fluorescent display tube. If this problem occurs, it indicates that the DSP is faulty or the user�s setting environment may be unsuitable. Refer to �3. SelfDiagnosis Mode for Servicing/Display of History of DSP Errors� on page 13 to identify the problems.
� 15 �
|
|
|
> |
|