There are currently no product reviews.
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
If the memory of the remote is already full, the USE MODE button flashes 8 times in quick succession and the remote automatically exits the learning mode.
Selecting the mode of the remote
You can switch the command mode (AV1 or AV2) of the remote. If the command mode of the receiver and the remote is different, you cannot use the remote to operate the receiver.
Repeat steps 1 through 5 to program up to 10 IR codes.
If programming is unsuccessful, check the following: â If the USE MODE button does not light up in step 1, the batteries are weak. Replace both batteries. â If the USE MODE button lights 4 times in quick succession in step 3, an error has occurred. Start again from step 1.
1 2 3
Press ?/1 while holding down USE MODE. Move the easy scroll key to select âMAINâ, then press the key to enter the selection. Move the easy scroll key to select âAV1â or âAV2â, then press the key to enter the selection.
To cancel programming
Press USE MODE during any step. The remote automatically exits the macro setting mode.
To delay the output of an IR code
Start over from step 1. In step 3, press the easy scroll key lightly (for less than 2 seconds). A 1 second delay is programmed. The USE MODE button lights twice slowly, then the remote automatically exits the macro setting mode.
The USE MODE button lights once (or twice for AV2), then the command mode switches.
To set the 2nd zone mode (North American models only)
You can use the remote to select the input for the 2nd zone. You can use the easy scroll key only for the 2nd zone.
To clear the programmed IR codes
Clear each macro step individually. In step 3, press the easy scroll key for more than 2 seconds. The IR code is cleared. The USE MODE button lights twice slowly, then the remote automatically exits the macro setting mode.
Press ?/1 while holding down USE MODE. Move the easy scroll key to select â2NDâ, then press the key to enter the selection.
The USE MODE button lights once, then the command mode switches.
To start macro play
Move the easy scroll key to select âM1â or âM2â, then press the key to enter the selection
To reset the remote to factory settings
Press ?/1, AV ?/1, and MASTER VOL â at the same time. The USE MODE button lights 3 times, then goes off.
If the Macro Play function does not work properly, program a delay between each operation. See âTo delay the output of an IR codeâ.