|
Who's Online
There currently are 5905 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
This manual is all I need to check and repair my equipment. Thank you....
;
this manual make me repair my vintage radio with easily.
Thank you for your best service
sukpra
;
A good manual. Had everything i needed to make the repair.
;
This manual is a complete guide, including later additions. It has all the necessary information about the replacement items. The material quality is great to read.
;
This manual is very helpful, correct shematic diagram, and good exploded view.Perfect!
Section 3 Troubleshooting
3-1. Judging Method When Image Does Not Appear
1. Flow chart
Picture does not appear
Check the indication on the indicator in the lower right of the front panel. (STAND BY)
STBY LED flashes
2 times
When error code is detected from panel.
3 times
When temperature increases.
4 times
When 5 V digital system power voltage decreases (2.5 V or less) or becomes excess voltage (6 V or more)
5 times
When 3.3 V digital system power voltage decreases (1.6 V or less) or becomes excess voltage (4 V or more)
6 times
When 6 V analog system power voltage decreases (3 V or less) or becomes excess voltage (7.2 V or more)
1
2
3
6
1
2
0.3 0.3 0.3 0.3 3
When the STBY LED does not flash, the power supply circuit is defective.
2. How to find PDP unit trouble 1) The power voltage for the PDP is supplied correctly. The power voltages are supplied from the switching regulator board CN6, CN23, CN33, CN42 and CN52 to the PDP panel. The four types of power voltage that are 3.3 V, 5 V, 55 V and 80 V are supplied.
2) The input signal is supplied to the PDP panel correctly. The LVDS signal is supplied to CN1 of the circuit board in the bottom of the PDP panel. (CN1 pin-1, pin-3, pin-5, pin-7, pin-9, pin-11, pin-13, pin-15, pin-17 and pin-19) If no images appears through the above conditions are satisfied, the PDP unit will be defective. 3-1
PFM-32C1/32C1E
|
|
|
> |
|