Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
Text excerpt from page 18 (click to view)
Attaching the unit stand
The unit stand allows you to place your Access Point in an upright position. When the unit stand is attached, wire cables are routed through the recessed groove.
Before attaching the unit stand
Make sure to write down the six-digit Access Point ID on the label attached on the bottom surface of the Access Point. Access Point ID
Category 5 Ethernet cable is recommended or you may not be able to attach the unit stand to the Access Point.
Attach the unit stand to the Access Point as shown in the figure below. Engage Joint A with Joint B and slide the Access Point in the direction indicated by the arrow until it clicks.
Groove z Tip
The unit stand may be attached in either direction.
To remove the unit stand
Slide the Access Point and unit stand in opposite directions to detach.