There are currently no product reviews.
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
good scans, all is clear. all pages in order. recommended
SECTION 4 TEST MODE
Outline â¢ In this set, overall adjustment mode is made available by entering test mode to perform automatic adjustment of CD and MO. In the overall adjustment mode, the disc is determined whether it is CD or MO and adjustments are performed in sequence. If a fault is found, the location of the fault is displayed. Also, in servo mode, each adjustment can be automatically made. Setting the Test Mode To enter the test mode, two methods are available : 1. Entering method with key input. Turn off the HOLD switch on the set. While holding down the p key on the set, press the following remote commander keys in the following order : +n+n=n=n+n=n+n =nPnP 2. Entering method by shorting the test point Solder bridge the test point TAP801 (TEST) on the main board (connect IC801 pin #â¢ to GND), and turn on the POWER.
Configuration of Test Mode The test mode has the configuration given below.
VOL + key p key Overall adjustment mode (Auto?) p key p key VOL â key p key Adjustment â key mode (Manu ?) Servo mode 000 +, â keys Audio mode 100 +, â keys Servo mode 300 Displays of the LCD on the remote commander are shown in parentheses.
+, â keys
Test mode Short : Test mode Open : Normal mode
to move the optical pick-up to the outer circumference and to the inner circumference respectively. â¢ When entering another mode, refer to the configuration of test mode. 1. Structure of Servo Mode
Servo mode 000 p key â key
+, â keys
Servo Mode â¢ Set the test mode, press the VOL â key and use the â key to set the servo mode. â¢ When the servo mode is set, use the + key and the = key
Display when test mode
Offset adjustment 010
011 to 013 *1 â key
Releasing the Test Mode 1. When test mode was entered with key input, turn off the POWER. 2. When test mode was entered by shorting the test point, turn off the POWER and open the solder bridge of TAP801 (TEST MODE) on the main board. Operation of Setting on Test Mode When the test mode is set, the LCD displays the following :
Laser power adjustment 020
021 to 024 p key *1 â key 2 (See page 8) 3
ROM version display LCD on remote commander
â¢ The cycle - the above ROM version display n All lit n All off - is repeated. (The ROM version is constantly displayed.) â¢ When the PLAY MODE key is pressed and hold down, the display at that time is held so that display can be checked.
*1 Repeatedly press â key to change the mode. (Refer to the following list for a description of each mode.)
Complete owner's manual in digital format. The manual will be available for download as PDF file aft…