|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Very good scan quality, only PC Board scan not enough contrast.
;
First of all I must say that I received the manual in just a few minutes after placing the order. The copy is well done and very readable. I will buy others soon... Thanks, Meyer
;
Good service manual. I gat all I want. Copy is good, but could be better. All clear and useful. I sincerely recommend.
;
The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.
;
Welcome. The scheme is clearly helped me to repair. Worth to download it.
MZ-E33
6-4. SCHEMATIC DIAGRAM � Refer to page 25 for IC Block Diagrams. � Waveforms
MINIDISC OPTICAL PICK-UP BLOCK
(MODE:PLAY)
1
* : The electrical components differ according to the version of the system control IC (IC801). When replacing the IC801, check its model name and add or remove D1001 and/or R1001 as shown below. RU6815MF-0004 (Ver 3.0) .... Add D1001 and R1001 RU6815MF-0005 (Ver 3.2) and later .... Remove D1001 and R1001
800mVp-p
IC501 @� TIME/DIV : 5 µsec
VOLT/DIV : 200mV AC
2
2.7Vp-p
23 µsec
IC601 #ª TIME/DIV : 10 µsec
VOLT/DIV : 1V AC
3
2.6Vp-p
482nsec
IC601 $¡ TIME/DIV : 200nsec
VOLT/DIV : 500mV AC
4
2.0 Vp-p
16.9344 MHz
IC601 $ª TIME/DIV : 20nsec
VOLT/DIV : 500mV AC
Note: � All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or less are not indicated except for electrolytics and tantalums. � All resistors are in � and 1/4 W or less unless otherwise specified. Note: The components identified by mark ! or dotted line with mark ! are critical for safety. Replace only with part number specified. � A : B+ Line. � Power voltage is dc 3 V and fed with regulated dc power supply from battery terminal. � Voltage and waveforms are dc with respect to ground under no-signal conditions. no mark : MD PLAY � Voltages are taken with a VOM (Input impedance 10 M�). Voltage variations may be noted due to normal production tolerances. � Waveforms are taken with a oscilloscope. Voltage variations may be noted due to normal production tolerances. � Signal path. J : MD
� 21 �
� 22 �
� 23 �
� 24 �
$4.99 MZE32 SONY Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|