|
|
|
Who's Online
There currently are 5889 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
complete part-lists and pcb layout, schematic diagram is good enlargable,
;
Excellent, fast delivery, excellent product. Good luck!
;
This manual is for the usa model only. But it is clear
, accurate and comprehensive, including board layouts and schematics.
I found it extremely useful for my mitsubishi dp-86da, but the same diagram would also work for the realistic lab5000 and hi fi 80. Thanks.
;
Great to have extra resources for Service Manuals, Now days you can really not trouble shoot efficiently without one , Wayne at IRIONS TV & ELECTRONICS REPAIR Clearwater , Fl. 33755 727-446-7955
 ;
For five bucks you can barely buy a hamburger. Or for the same five bucks you can buy a service manual. Much more useful. (and better for your health, depending on where you buy your hamburgers).
Yes, there are free manual sites out there, but if they don't have what you want, you have to pay.
And five bucks isn't much. Not for full specs, schematics and adjustment and parts replacement procedures.
My only criticism is that grayscale illustrations aren't well rendered, but I've seen worse.
Schematics and text are clear.
I'll be happy to purchase from here again.
Mike
[email protected]
5-1-4. Basic Knowledge
5-1-4. Basic Knowledge
1. Tape Cleaner c Never touch the edge of the tape cleaner with bare hands. It is in danger of cutting your finger because the tape cleaner has a sharp edge. Pay careful attention when replacing or adjusting the peripheral parts. 2. Tools Before use a tool, clean the surface of the tool using a cleaning cloth moistened with cleaning fluid. . Cleaning cloth: 3-184-527-01 . Cleaning fluid: 9-919-573-01 Be careful not to damage the tool. If the flawed tool is used, adjustment cannot be performed correctly. 3. Note (1) Grease and Oil Please use only the specified grease and oil. If the different grease or oil is used, major malfunctions may be caused due to differences in viscosity and ingredients. And if the grease or oil that has been mixed with dust is used, major malfunctions may be caused. Use the following grease and oil. . Grease (SGL-505): 7-661-000-10 . Oil: 7-661-018-18 Apply just enough grease to create a thin film on the surface of the part. Any grease that adheres to other surrounding parts must be wipe using a gauze or soft cloth. A drop of oil is defined as follows: About the amount that will adhere to the end of a stick 2 mm in diameter, as shown in the figure. Do not use the grease and oil except for specified portions.
2 mm (diameter) Oil
Oil
(2) Stop Washer and E Ring It should not be used the stop washer and E ring once again. It is recommended checking a required stop washer and E ring before replacement, and preparing more than required number.
5-8
MSW-A2000/A2000P
|
|
|
> |
|
