very helpful, the information in these manuels are very detailed
Text excerpt from page 14 (click to view)
Presetting radio stations (continued)
To Do this
Setting presets through manual tuning
Tune in a station Follow the procedure described in with a weak âSetting presets through manual signal tuningâ. Set another station to an existing preset number Start over from step 1. After step 3, press . or > (or PRESET â or + on the remote) repeatedly to select the preset number you want to store the other station.
1 Press TUNER/BAND repeatedly to
select âFMâ or âAMâ.
2 Press m or M (or TUNING â or + on
the remote) repeatedly to tune in the desired station.
3 Press TUNER MEMORY on the remote.
A preset number appears in the display. The stations are stored from preset number 1.
To change the AM tuning interval (except for the European and Middle Eastern models)
The AM tuning interval is factory-set to 9 kHz (10 kHz in some areas). To change the AM tuning interval, tune in any AM station first, then turn off the system. While holding down TUNER/BAND, turn the system back on. When you change the interval, all the AM preset stations are erased. To reset the interval, repeat the same procedure.
4 Press . or > (or PRESET â 5 Press ENTER on the remote.
or + on the remote) repeatedly to select the desired preset number.
6 Repeat steps 1 to 5 to store other
You cannot change the AM tuning interval in the Power Saving Mode.
â¢ The preset stations are retained for half a day even if you disconnect the mains lead or if a power failure occurs. â¢ To improve broadcast reception, reorient or move the supplied antenna near a window or outdoors.