There are currently no product reviews.
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
The owners manual is very good. all my how to questions were answered in detail.
Irrespectively of this manual exist only germany language, it's useful - although i need some additional task to translate: My english is bad, but usable - but i really dont speak germany. :)
z Additional Information
To EAR, EARPHONE, or @ of audio equipment MIC Connecting cord (not supplied)
The unit does not operate.
m m m m m m m The batteries have been inserted with incorrect polarity. The batteries are weak. Replace both batteries with new ones. The AC power adaptor is not firmly connected. The batteries have been inserted; however, the AC power adaptor is also connected but not plugged into the wall outlet. There is no cassette. HOLD function is activated. Slide HOLD/EJECT to release HOLD function. The TAPE SPEED switch is set between the 1.2 cm and 2.4 cm position. The batteries are weak. Replace both batteries with new ones. The earphone is plugged in to EAR. Disconnect it. The volume is turned down completely.
Various Ways of Recording
p HOLD Display window EAR REC PAUSE/REC VOR FF/CUEâ¢REW/REVIEW
REC PAUSE REC
Recording with the supplied remote control microphone
Connect the supplied remote control microphone to MIC. The built-in microphone will be disconnected and the sound through the remote control microphone will be recorded. The power to the microphone is supplied from this unit. As the recording sensitivity of the remote control microphone is higher than that of the built-in microphone, it is useful to record soft sounds in a quiet place. To start recording, insert a cassette and slide REC PAUSE/REC toward âRECâ while holding the center button down. M-98V
How to use the carrying case
Place accessories here.
This warranty is valid only in the United States.
Operate the unit only on 3V DC. For AC operation, use the AC power adaptor recommended for the unit. Do not use any other type. For battery operation, use two R03 (size AAA) batteries.
On the unit 1 2 3
Insert a cassette. Adjust the sound of the connected equipment. Slide REC PAUSE/REC toward âRECâ while holding the center button down.
â¢ Use only the y (standard microcassettes) with this unit. Non-standard cassettes cannot be used because their âLâ dimension (see illustration) is different.
The unit stops to operate a little after you have pressed a button.
m m m
VOR (Voice Operated Recording)
The VOR system works only while recording. Set VOR to ON first and slide REC PAUSE/REC toward âRECâ while holding the center button down. The unit automatically starts recording the sound and pauses when there is no sound (you can save tapes and batteries). When you use this system in a noisy place the unit stays in the recording mode. If the sound is too soft, on the contrary, the unit will not start recording. When you do not use this function, set VOR to OFF. You can set VOR to ON while recording too. Notes
â¢ The VOR system depends on the environment or operating conditions. Set MIC SENS to H or L depending on the conditions. If you cannot get the desired results, set VOR to OFF. When recording with the supplied remote control microphone, the recording may not stop even if the sound becomes very soft, because the recording sensitivity of the remote control microphone is higher than that of the built-in microphone. â¢ When using the VOR system, the unit starts recording only when a sound is detected, therefore, the beginning of the word may not be recorded. For an important recording, we recommend to recording without the VOR system.
Only standard microcassette have a small indentation of side A.
No sound comes from the speaker. The sound drops out, sound quality becomes worse or sound has excessive noise.
m m m m The volume is turned down completely. The batteries are weak. Replace both batteries with new ones. The record/playback head is contaminated. Clean it. The earphone plug/microphone plug is dirty. Clean the plug, insert it into the jack, turn it few times, then disconnect it and connect it again.
Place M-98V here.
MIC Supplied remote control microphone
Using Other Functions
Display window COUNTER RESET HOLD/EJECT TAPE SPEED
Approx. 5 mm
Approx. 2.5 mm
â¢ Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. â¢ Should any solid object or liquid fall into the unit, remove the batteries or disconnect the AC power adaptor, and have the unit checked by qualified personnel before operating it any further. â¢ When you do not use the unit for long, remove the batteries to avoid damage caused by battery leakage and subsequent corrosion. Keep personal credit cards using magnetic coding or spring-wound watches etc. away from the unit to prevent possible damage from the magnet used for the speaker. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer.
To pause playback/recording with the remote control microphone
Slide PAUSE on the remote control microphone in the direction of the arrow. To release pause, slide PAUSE back to the original position. Note
When operating with the remote control microphone, you cannot pause using the P button on the unit.
The speed is too fast or too slow in the playback mode.
m Improper setting of the TAPE SPEED switch. Set it to the same speed as that used for recording.
y (normal position type)
Tape speed is faster than the normal playback speed.
m m The FAST PB switch is slid in the direction of the arrow. The VOR system is working. When you do not use the VOR system, set VOR to OFF.
Recording is interrupted.
This function locks the unit to prevent it from operating when you accidentally press a button except COUNTER RESET. To lock the unit, set HOLD/EJECT to H. The H indicator flashes in the display window.
2-track 1 channel monaural
Recording cannot be erased completely.
m The erase head is contaminated. Clean it.
400 - 3,000 Hz (2.4 cm/s)
Approx. 2.8 cm (1 1â8 in.) dia.
Start recording during playback
Slide REC PAUSE/REC toward âRECâ while holding the center button down during playback, recording starts immediately. It is useful when you want to re-record the portion which was just recorded.
Recording from various sound sources
Notes (Before recording)
â¢ When connecting cords, be sure you connect plugs firmly. â¢ Make a trial recording to make sure that you made connections correctly and adjusted the volume properly. â¢ The following examples use Sony products. If you have any problems when using other products, read the instruction manual of those products.
Should any problem persist after you have made these checks, consult your nearest Sony dealer.
To check the direction of the tape in the display window
Display Upper side is recorded or played back. Display Reverse side is recorded or played back.
250 mW Microphone input jack (minijack/plug in power) sensitivity 0.37 mV for 3 kilohms or lower impedance microphone
Recording cannot be made.
m m m m The recording is paused using the connected remote control microphone. The batteries are weak. Replace both batteries with new ones. There is no cassette. The tab on the tape has been removed. (Even if only the tab on the reverse side is removed, recording cannot be made.) To reuse the tape for recording, cover the tab hole with adhesive tape. To record on one side only, insert a cassette with the side to start recording facing away from the lid (reverse side). The record/playback head is contaminated. Clean it. MIC SENS has been set improperly when VOR function is activated. Connection is made incorrectly. The VOR system is working. When you do not use VOR, set VOR to OFF. The batteries are weak. Replace both batteries with new ones. The cassette is inserted front side back. The cassette is inserted into the wrong part (it should be inserted into the lid side). The cassette is not inserted completely.
Earphone jack (minijack) for 8 - 300 ohms earphone
Review the portion just recorded
When you press EASY SEARCH + or â during recording, the unit stops recording and starts playback after fast-forwarding or rewinding for as much as you pressed the button. (For details, see the âSearching for the point you want to playâ section of âPlaying a Tapeâ.) You can also start playback after fast-forwarding or rewinding by sliding FF/CUEâ¢REW/REVIEW during recording and releasing the button at the point to start playback.
3 V DC batteries size AAA (R03) Ã 2/External DC 3 V power sources Approx. 60.5 Ã 93.9 Ã 26.0 mm (2 1â2 Ã 3 3â4 Ã 1 11â16 in.)
Dimensions (w/h/d) (incl. projecting parts and controls) Mass Capstan Cotton swab
Approx. 130 g (4.6 oz.) Supplied accessories Remote control microphone (1) Microcassette tape MC-30 (1) Earphone (1) Carrying case (1) Hand strap (1) Batteries R03 (SB) (2) (âSony World Modelâ only) Design and specifications are subject to change without notice.
Recording with an external microphone
Connect a microphone to MIC. Use a microphone of low impedance (less than 3 kilohms). When using a plug-in-power system microphone, the power to the microphone is supplied form this unit. To start recording, insert a cassette and slide REC PAUSE/REC toward âRECâ while holding the center button down. Note
When using an external microphone, use a monaural type microphone. If a stereo microphone is connected, this unit may not operate properly. When the monaural microphone is equipped with a 3-polarity mini plug, use the Plug Adaptor PC-236MS to convert to 2 polarity.
The indication will disappear when you have not operated the unit for more than one minute. To display the indication, press p or P.
TAPE SPEED selector
2.4 cm: For optimum sound (recommended for normal use). A 60-minute recording can be made using both sides of the MC-60 microcassette. 1.2 cm: For longer recording time. A 120-minute recording can be made using both sides of the MC-60 microcassette.
m m m m
You cannot open the cassette compartment lid.
m m m m m m m
To clean the tape heads and path
Wipe the heads, pinch roller, and the capstan with a cotton swab moistened with alcohol every 10 hours of use. After wiping with alcohol, be sure to wipe with a dry cotton swab or wait until the tape heads and path dry before inserting a cassette. You can see the inside through the window of the cassette compartment lid. Clean the pinch-roller from top to bottom by rotating it. Use a soft cloth slightly moistened in water. Do not use alcohol, benzine or thinner.
You cannot insert the cassette.
While the upper side of the tape is running (âFWDâ appears in the display window), the numbers in the tape counter increase. While the reverse side is running (âREVâ appears in the display window), they decrease. Press COUNTER RESET and release it within 2 seconds to return to 000.
You cannot close the cassette compartment lid.
Recording from another equipment
Connect another equipment to MIC using the RK-G64HG connecting cord (For âSony World Modelâ: in Japan, use the RKG64, not supplied).
Playback is not possible even if you press 9(.
The playback is paused using the connected remote control microphone. The batteries reached the end of both batteries with new ones. The tape has are weak. Replace the reverse side.
To clean the exterior
To return the tape to the position of 000
Press COUNTER RESET for more than 2 seconds until ZERO STOP appears in the display window. During rewind or REVIEW, the tape stops at 000. Press COUNTER RESET for more than 2 seconds to make the ZERO STOP indicator disappear.
To clean the microphone plug
Clean the plug of the supplied remote control microphone periodically with a soft dry cloth. Otherwise, noise may be recorded. When using an optional external microphone, clean its plug in the same way.
During CUE/REVIEW the tape stops or does not run. You cannot fast-forward or rewind.
m m The batteries are weak. Replace both batteries with new ones. The zero stop counter function works. Press COUNTER RESET for more than 2 seconds to make ZERO STOP disappear form the display window.
Complete service manual in digital format (PDF File). Service manuals usually contains circuit diagr…