|
Who's Online
There currently are 5816 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
A comprehensive Operating and Service Manual. All schematics are complete and easy to read. The PCB drawings and complete parts list are very helpful. I would definitely recommend this manual.
;
SCANNING OF HIGH QUALITY
VERY, VERY HIGH VELOCITY DOWNLOAD
VERY GOOD PRICE,
TRUE SATISFIED, THANKS
;
Genuine Toshiba owner's manual. Couldn't really ask for more. And written in understandable English in contrast to a few recent experiences I have had with manuals for other equipment other than Toshiba but made in China and written in "Chinglish"!
;
I purchased a vintage Sony mixer off eBay and within the hour was able to locate and purchase the manual for it.I mean really,where else can you find a manual for a product made in 1983!? It was easy to find and purchase/download the manual I needed.I will use this site again for other equipment I have! Great site!
;
manual de usuario perfecto y completo de buena calidad de impresion y muy detallado ideal !
English
� This lamp is designed for use with the Sony projector. � Be sure to confirm that this lamp is usable with your projector before using it by reading the Operating Instruction or Installations Manual for Dealers supplied with your projector.
3
Loosen the three screws with a Phillips screwdriver.
6 7 8 9
Tighten the three screws loosen in step 3 to secure the lamp unit to the projector. Replace the lamp cover and tighten the two screws. Replace the top panel and tighten the two screws. Connect the power cord and set the projector to standby mode.
About lamp replacement
Attaching the lamp may cause fire or injury to persons. Users should ask a qualified Sony representative to attach the lamp.
10Press the RESET, <, ,, and ENTER buttons on the
remote control in this order for less than five seconds each.
Replacing the lamp unit
Note � Before replacing the lamp unit, be sure to turn off the projector and disconnect the power cord of the projector. When replacing the lamp unit after using the projector, wait at least one hour to allow the lamp unit to cool. � Whenever you replace the lamp unit, be sure to replace the air filter with a new one. The illustrations below show the case of replacing the lamp unit with the projector installed on the ceiling. Disposal the used lamp The used lamp contains Mercury, dispose according to local, state or federal laws. As the materials used in this lamp are similar to those of a fluorescent lamp, you should dispose of a used projector lamp in the same way as a fluorescent lamp.
4
Holding the lamp unit with your hand, push back the stoppers on the left and right sides, then pull out the lamp unit.
Specifications
Dimensions 180 � 157 � 163 mm (7 1/8 � 6 1/4 � 6 1/2 inches) (w/h/d)
1
Loosen the two screws fixing the top panel at the rear of the projector using the supplied screwdriver (1), then slide the top cover backward and lift it to remove (2).
Mass 1.8 kg (3 lb 15 oz) Supplied accessories Screwdriver (1) Operating Instructions (1)
1
2
5
Insert the new lamp unit straight all the way in until it is securely in place, and pull out both the stoppers until you hear a click.
2
Loosen the two screws fixing the lamp cover using the supplied screwdriver to remove the lamp cover.
|
|
|
> |
|