There are currently no product reviews.
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
Super nice! Good to have a manual in digital format.
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
Presetting radio stations
You can preset 20 stations for FM and 10 stations for AM.
To set another station to the existing preset number
Start over from step 1. After step 4, press +/â€“ to select the preset number you want to store for another station. You can add a new preset number after the last preset number.
To erase the preset station
1 Press TUNER/BAND repeatedly until
the band you want appears.
Each time you press this button, the band changes as follows: FM y AM
1 Hold down TUNER MEMORY until a preset
2 Press TUNING MODE repeatedly until
3 Press +/â€“ until the frequency indication
starts to change.
DOLBY NR OFF
Scanning stops when the system tunes in a station. â€śTUNEDâ€ť and â€śSTEREOâ€ť (for a stereo program) appear.
DOLBY NR OFF
2 Press +/â€“ to select the preset number you
want to erase.
Select â€śALL ERASEâ€ť when you want to erase all the preset stations.
3 Press ENTER.
â€śCOMPLETEâ€ť appears. When you erase a preset number, the preset number decreases by one and all preset numbers following the erased one are renumbered.
To change the AM tuning interval (Except for the European and Middle Eastern models)
The AM tuning interval is factory set to 9 kHz (10 kHz in some areas). To change the AM tuning interval, tune in any AM station first, then turn off the power. While holding down the ENTER button, turn the power back on. When you change the interval, AM preset stations will be erased. To reset the interval, repeat the same procedure.
4 Press TUNER MEMORY.
The next available preset number flashes in the display. The stations are stored from preset number 1.
DOLBY NR OFF
5 Press ENTER.
â€śCOMPLETEâ€ť appears and the station is stored.
6 Repeat steps 1 to 5 to store other
stations. To tune in a station with a weak signal
The preset stations are retained for half a day even if you unplug the power cord or if a power failure occurs.
Press TUNING MODE repeatedly until â€śMANUALâ€ť appears in step 2, then press +/â€“ to tune in the station.