There are currently no product reviews.
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
Manual was complete and available promptly, since I had lost my original manual. Very good response.
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
excellent quality, contains circuits and scan quality, 110 pages
It was easy done, and I got exactly what I was looking for.
Presetting radio stations
You can preset 20 stations for FM and 10 stations for AM.
To set another station to the existing preset number
Start over from step 1. After step 4, press +/â€“ to select the preset number you want to store for another station. You can add a new preset number after the last preset number.
To erase the preset station
1 Press TUNER/BAND repeatedly until
the band you want appears.
Each time you press this button, the band changes as follows: FM y AM
1 Hold down TUNER MEMORY until a preset
2 Press TUNING MODE repeatedly until
3 Press +/â€“ until the frequency indication
starts to change.
DOLBY NR OFF
Scanning stops when the system tunes in a station. â€śTUNEDâ€ť and â€śSTEREOâ€ť (for a stereo program) appear.
DOLBY NR OFF
2 Press +/â€“ to select the preset number you
want to erase.
Select â€śALL ERASEâ€ť when you want to erase all the preset stations.
3 Press ENTER.
â€śCOMPLETEâ€ť appears. When you erase a preset number, the preset number decreases by one and all preset numbers following the erased one are renumbered.
To change the AM tuning interval (Except for the European and Middle Eastern models)
The AM tuning interval is factory set to 9 kHz (10 kHz in some areas). To change the AM tuning interval, tune in any AM station first, then turn off the power. While holding down the ENTER button, turn the power back on. When you change the interval, AM preset stations will be erased. To reset the interval, repeat the same procedure.
4 Press TUNER MEMORY.
The next available preset number flashes in the display. The stations are stored from preset number 1.
DOLBY NR OFF
5 Press ENTER.
â€śCOMPLETEâ€ť appears and the station is stored.
6 Repeat steps 1 to 5 to store other
stations. To tune in a station with a weak signal
The preset stations are retained for half a day even if you unplug the power cord or if a power failure occurs.
Press TUNING MODE repeatedly until â€śMANUALâ€ť appears in step 2, then press +/â€“ to tune in the station.