|
Who's Online
There currently are 5945 guests and 1 member online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
The manual I purchased was exactly what I needed to repair my Toshica television. The manual contained schematics and troubleshooting information that was very helpful.
;
Il download del Service Manual JVC HR 4100 non é stato eseguito
;
The Service Manual was just as expected, complete with schematics and I was able to download it in less than an hour after I ordered it. The only problem with these is that the schematics are hard to read due to the small font. I could remedy this by printing them on a larger printer.
;
Very fast, clear and usefull site !
Also this Service Manual are very well maked and with a very good definition !
Very fast download speed !
Recomended Seller !
;
The manual you sent me was excellent. It included clear, readable diagrams and a usable parts list. I would surely use your service again. Thanks
KV-XS29M80/XS29M97
RM-954 RM-953
Notes � If you connect a monaural VCR, connect the yellow plug to (the yellow jack) and the black plug to -L (MONO) (the white jack). � If you connect a VCR to the � (antenna) terminal, preset the signal output from the VCR to the program number 0 on the TV. � If both (S video input) and � 1 (video input) at the rear of your TV are input at the same time, the (S video input) is automatically selected. To view � 1 (video input), disconnect the S video cable. � Do not connect video equipment to � 3 (video input) at the front and the rear of your TV at the same time; otherwise the picture will not be displayed properly on the screen. � When no signal is input to the connected video equipment, the TV screen becomes blue.
Connecting the 3D WOOFER
You can enjoy high quality sound by connecting the 3D WOOFER.
3D WOOFER Rear of TV
1
Red wire
2
Step 2
R L 2 Y 3 CB CR
Insert the batteries into the remote
WOOFER (8 )
Black wire
1
L(MONO) R
Note � Do not use old batteries nor use different types of batteries together.
1 2
Attach the 3D WOOFER into the footholds on the top of your TV. Connect the wires to the 3D WOOFER (8�) terminals at the rear of your TV. The red wire should be connected to the � red terminal and the black wire to the � black terminal.
� 24 �
Step 3
Preset the channels automatically
Front of TV
1
Using Your New TV
2
Notes � Connect only the supplied 3D WOOFER; otherwise your TV may malfunction. � Unplug your TV from the wall outlet when connecting the 3D WOOFER. � To prevent a malfunction caused by a short circuit of the terminals, make sure that none of the 3D WOOFER wire strands stick out, making contact with the neighbouring speaker terminal.
Tip � If you want to stop the automatic channel presetting, press MENU twice. Note � If your TV has preset an unwanted channel or cannot preset a particular channel, then preset your TV manually (see page 31).
Using Your New TV
5
6
Using Your New TV
|
|
|
> |
|