|
Who's Online
There currently are 466 guests and 1 member online.
|
Categories
|
Information
|
Featured Product
|
|
|
 |
|
There are currently no product reviews.
 ;
perfect copy, im very satisfied, i was need the diagram over the powersupply and
the copy was very sharp
 ;
This is exactly the service manual I needed.
Complete with all schematics, partslists, PCB layouts and alignment instructions.
This manual covers both the T-4970 en T-488F Onkyo tuner.
 ;
IF PRINTED CIRQUIT BOARD WIRING VIEW WAS ONE TONE LIGHTER, THEN 5 STAR RANK HAS TO BE MY CHOISE.
 ;
Very usefull, good quality drawings !
Muito útil encontrei todas as informações necessárias.
 ;
Wanting to repair a neighbours tape recorder I needed the necessary information, it makes it easier. Although the service manual is described as "Language : English" To my dismay I found that it is entirely written in German, a language I do not understand. At least I now have the schematics which will help of sorts. I may not use this service again due to the laguage difficulty after all when it states English you do not expect it to be entirely in another language.
KV-PG21P40/PG21M70/PG21P70
2-7. PICTURE TUBE REMOVAL Note:
• Please make sure the TV set is not in standing position before removing necessary CRT support located on bottom right and left.
• REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon paint on the CRT.
!™ Cushion (50x550) DGC 8 Demagnetic coil !¡ Holder DGC
• REMOVING PROCEDURES
RM-952
!£ Cushion (35x250) DGC
a a 1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
7 Chassis assy 4 Four screws (washer head) (BVTP 3 × 12) 2 CV board 5 Deflection yoke 3 Speaker (5 × 9cm) !º Two screws (Tapping 5+ Crown Washer) 6 Tension spring 9 Two screws (Tapping 5 + Crown Washer)
A Board
b b
12 –
Coating earth assy CRT Support Block !∞ Picture tube
2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.
c
1 Anode cap
Anode button
3 When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the
Screw Location
arrow c.
•
HOW TO HANDLE AN ANODE-CAP
CRT Support Block
1 Do not damage the surface of anode-caps with sharp shaped objects. 2 Do not press the rubber too hard so as not to damage the inside of anode-cap. A metal fitting called the shatter-hook terminal is built into the rubber. 3 Do not turn the foot of rubber over too hard. The shatter-hook terminal will stick out or damage the rubber.
Slim Beznet !¢ Cushion
|
|
 |
> |
|