|
Who's Online
There currently are 6012 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I'm very happy that you all are performing an incredible good job. Furthermore what you did is very useful for all people as me that have electronics as an hobby.Thank you!!!!!
;
Manual found fast and good quality, very helpfull service
;
8-17-12 Been using the sight for about 6 months. Fast Downloads and top quality
Manuels !
;
Everything was great, the manual, the response time, the simplicity of the order, and the
Price. The only thing that I could possible say on a negative note would be that the manual I ordered was more for a service tech. There were a lot of schematic diagrams that didn't help me solve the problem. However I would order again and recommend the web sight to others.
;
I'd been looking for this manual for awhile. Exactly what I needed - and at an excellant price. Thanks!
2-7. PICTURE TUBE REMOVAL Note:
� Please make sure the TV set is not in standing position before removing necessary CRT support located on bottom right and left.
� REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon paint on the CRT.
� REMOVING PROCEDURES
!¢ Cushion
a
!£ Demagnetic coil
!� Holder DGC
a
!� Chassis assy 4 Two screws (washer head) (+P 4 � 16)
1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
b b
!¡ CV board 9 Tension spring 7 Two screws (Tapping 7+ Crown Washer) PWB Bracket
!º Deflection yoke 5 Speaker (15 � 6.5cm) 6 Two screws (Tapping 7+ Crown Washer)
2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.
c
� 11 �
Coating earth assy 8 Anode cap
CRT Support Block
Screw Location 2 screws (+BVTP 4 � 16) 2 Two screws (washer head) (+P 4 � 16)
Anode Button
Beznet Hook
3 When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c. 1 Do not damage the surface of anode-caps with sharp shaped objects. 2 Do not press the rubber too hard so as not to damage the inside of anode-cap. A metal fitting called the shatter-hook terminal is built into the rubber. 3 Do not turn the foot of rubber over too hard. The shatter-hook terminal will stick out or damage the rubber.
�
HOW TO HANDLE AN ANODE-CAP
!§ Picture tube 1 Cushion
3 Speaker (15 � 6.5cm)
CRT Support Block
KV-HA21P50
RM-969
|
|
|
> |
|