|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Excellent quality and quickly delivered manuals at a fair price. Great care is taken in the reproduction process. Even photographs and highly detailed drawings are as clear as in the original. That cannot be said for some freelance manual copies I have obtained from the web. If you have exhausted your internet search of technical manuals, try Owner-Manuals.com. If they do not have it, I do not think it exists. Perhaps, if requested, they may be able to find it. Their resources are certainly greater than most. Shopping here certainly beats waiting for months or years for the manual you seek to appear in an internet auction or garage sale.
;
Very detailed product, also it is a scanning from original, very useful if you have to service this type of amplifier ! Very good product, very hard to find!
;
the Manual was made available as promised, the scans were excellent..Good Work !!!
;
It's complete and helpful manual with good quality of scan. Thanks very much.
;
The service was quick and simple, finding the service manual easy and it appears to be the original with colour schematics. It contained the info I was after and so sorted the problem.
I have copied it to CD and attached the envelope to the inside back cover of the owners manual. Good manual and excelent service. Robin Wood, Wood Electronics, New Zealand.
KV-B14K3
RM-849S
SECTION 4 CIRCUIT ADJUSTMENT
4-1. A BOARD ADJUSTMENT
ANTI PAL, LINE CRAWLING ADJUSTMENT (RV301, RV302, T301) � ANTI PAL ADJUSTMENT 1. Input the PAL color-bar signal. 2. Set the PIC, COL and BRT controls to normal. 3. Connect the oscilloscope to pin 3 of CN301 connector. 4. Adjust RV301 (SBM) and RV302 (PHASE) to obtain the waveform as shown below.
RV301 SBM RV503 V. SIZE RV502 V. LIM CV358 CV443 T301 RV551 V. CENT RV302 PHASE RF. AGC
S801
H. CENT
IC001
IC301
wrong pattern
/
right pattern
� LINE CRAWLING ADJUSTMENT 1. Input the PAL color-bar signal. 2. Set the PIC, COL, and BRT controls to normal. 3. Connect the oscilloscope to pin 3 of CN301 connector. 4. Adjust T301 for minimum line crawling.
A BOARD � component side �
L807
IF201
RF AGC ADJUSTMENT (IF201) 1. Receive a strong off-air signals. 2. Adjust RF AGC VR control so that snow noise and crossmodulation disappear from the picture. A�P�C ADJUSTMENT (CV443) (PAL) 1. Short circuit between pin 4 and pin $¶ of IC301 with jumper. 2. Input the PAL color-bar signal. 3. Set the PIC, COL and BRT controls to normal. 4. Adjust CV443 for suitable color intensity. 5. Remove the jumper.
L807
H. SIZE (HORIZONTAL SIZE)
RV503
V. SIZE (VERTICAL SIZE)
RV502
V. LIN (VERTICAL LINEARITY)
S801
H. CENT (HORIZONTAL CENTER)
RV551
V. CENT (VERTICAL CENTER)
� 14 �
|
|
|
> |
|