|
Who's Online
There currently are 5633 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Excellent!! Got what I need and very fast!! Thank You
;
Manual acquired with good resolution, complete in all its pages, very good policy of the folder where are saved all products purchased.
;
Service manual very complete and clear. It was very helpfull for my work.
;
This is the 2nd time I download manuals from this website and I can say it's what I was expecting. It contains schematic, layout (decent quality), short description, parts and dissasembly instructions. I recomend it for anyone who wants to repair/modify this device.
;
Very useful Service Manual! With it I was able to identify the damaged pots in my old amplifier, purchase the adequate replacements and make myself the repair.
I have again my old amplifier, still a very good one that I will keep for as many years as I can!
Thanks to Owner Manuals!
KD-32FS130/36FS130
SECTION 2: SET-UP ADJUSTMENTS
The following adjustments should be made when a complete realignment is required or a new picture tube is installed. These adjustments should be performed with rated power supply voltage unless otherwise noted. Set the controls as follows unless otherwise noted: VIDEO MODE: Pro PICTURE CONTROL: Normal BRIGHTNESS CONTROL: Normal
Perform the adjustments in order as follows: 1. Beam Landing 2. Convergence 3. Focus 4. Screen (G2) 5. White Balance Note Test Equipment Required: 1. Color Bar Pattern Generator 2. Degausser 3. DC Power Supply 4. Digital Multimeter
2-1. BEAM LANDING
Before beginning adjustment procedure: 1. Feed in the white pattern signal.
6. Switch over the raster signal to red and blue and con�rm the condition. 7. When the position of the de�ection yoke is determined, tighten it with the de�ection yoke mounting screw. 8. If landing at the corner is not right, adjust by using the disk magnets.
Adjustment Procedure
1. Input a raster signal with the pattern generator. 2. Loosen the de�ection yoke mounting screw, and set the purity control to the center as shown below: Purity Control
Purity control corrects this area.
3. Turn the raster signal of the pattern generator to green. 4. Move the de�ection yoke backward, and adjust with the purity control so that green is in the center and red and blue are even on both sides.
Disk magnets or rotatable disk magnets correct these areas (a-d).
a c
b d
Deflection yoke positioning corrects these areas. b
Blue Red Green
d a c
5. Move the de�ection yoke forward, and adjust so that the entire screen becomes green.
KD-32FS130/36FS130
29
|
|
|
> |
|