|
|
|
Who's Online
There currently are 5697 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was complete, parts list, adjustment procedures, etc. No worries
 ;
Very usefully, I could find the trouble clearly with that manual.
;
Bon produit. Permet de corriger les couleurs et de redonnez un petit coup de jeune à vos vieilles vidéos. On regrettera juste le manque d'une prise s-vidéo.
;
Quality scan of the actual service manual, just what I was looking for.
;
Straightforward ordering process. Service manual scan was clear & easy to read. Very comprehensive instructions for alignment. Excellent, thank you.
ICD-MX20/MX20VTP SECTION 3 TEST MODE
[Test Mode] The following checks can be implemented using the Test Mode. How to Enter the Test Mode To enter the test mode, turn ON the HOLD switch while pressing the MENU key and VOLUME + key at the same time with the power on. How to Exit the Test Mode Exit the test mode by turning OFF the power. Initial Status of the Test Mode When the machine enters the test mode, the LCD display appears as shown below.
F/W version of CPU (DSP block)
1. Version test � Version of the respective modules are verified.
F/W version of CPU (ARM block) F/W version of SUB-SPU
2. Key Chk + Format test � Perform the key check by pressing the keys. The NAND formatting (deleting all events) and the default settings of the menus (default language and LCD contrast remain unchanged) are executed at the same time.
The checked key is display.
Select the desired item by using the > / . key, and press the Nx button to set the selection.
Total of 15 keys* are counted. When all checks are completed, the back-Light turns on for 0.5 seconds The NAND formatting (deleting all events) and the befault settings of the menus are completed.
Selecting items.
* Nx / > / . / MENU /
Setting by the button
/ REC/PAUSE zX / STOP x / VOLUME + / VOLUME � / DIVIDE / A-B / DPC (ON/OFF) / VOICE UP (ON/OFF) / DIRECTNT (ON/OFF) / HOLD
3. Language test � Check the language and select the language. (Default language is Japanese.) � Press VOLUME + button for English (ENG). � Press A-B button for Japanese (JPN). 4. Loop Back test Execute the DSP LOOP BACK. 5. Beep test � Beep sound of 1.3 kHz or 2 kHz is output. � Press the Nx key to start outputting and press the x button to stop. 6. LCD Cont test � Adjust the LCD contrast. Default value is 07. � Adjust the LCD contrast using the > / . key. 7. RTC Int test � Perform the self test of the RTC.. 8. Battery test � The detected A/D value of the battery remaining power is checked.
10
|
|
|
> |
|
