Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
Text excerpt from page 38 (click to view)
Troubleshooting (continued)
There is no sound or only a very low-level sound is heard from the center or/and surround speakers.
There is no sound from a specific component.
� Check that the component is connected correctly to the audio input jacks for that component. � Check that the cord(s) used for the connection is (are) fully inserted into the jacks on both the receiver and the component. � Check that you have selected the correct component on the receiver.
There is no sound from one of the front speakers.
� Make sure the sound field function is on (press SOUND FIELD +/�). � Select a sound field containing the word �C.ST.EX� (page 21). � Adjust the speaker level (page 18). � Make sure the center or/and surround speaker size parameter is set to �SMALL� or �LARGE� (page 17).
There is no sound from the active sub woofer.
� Check that the component is connected correctly to the audio input jacks for that component. � Check that the cord(s) used for the connection is (are) fully inserted into the jacks on both the receiver and the component.
The multi channel surround effect of the Dolby Digital or DTS is not obtained.
� When you select NORM. SP., make sure the sub woofer is set to �YES� (see page 14). � Check that the sub woofer is connected correctly and securely. � There is no sound output from the SUB WOOFER terminal depending on the sound field (back page).
The FM reception is poor.
� Check that the DVD software, etc. is recorded in Dolby Digital or DTS format. � If you connect the DVD player, etc. to the digital input jack on this system, check the audio setting (for digital audio output) of the component. � Check that the audio track is correctly selected on the DVD player. (Check the audio setting of the DVD menu.)
The left and right sounds are unbalanced or reversed.
Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna as shown below. If you connect the receiver to an outdoor antenna, ground it against lightning. To prevent a gas explosion, do not connect the ground wire to a gas pipe.
Outdoor FM antenna
� Check that the speakers and components are connected correctly and securely. � Adjust balance parameters in the LEVEL menu.
There is severe hum or noise.
Receiver
ANTENNA
FM 75� COAXIAL
U
AM
Ground wire (not supplied) To ground
� Check that the speakers and components are connected securely. � Check that the connecting cords are away from a transformer or motor, and at least 3 meters away from a TV set or fluorescent light. � Move your TV away from the audio components. � The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.
