There are currently no product reviews.
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Generally speaking good copy; a few pages too hard contrast...
Good service and communication.
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
Clear and easy to read. All details as expected. Price acceptable , and quick delivery.
Before receiving broadcasts, make sure you have connected FM and AM antennas to the receiver (page 7).
â¢ If you do not remember the precise frequency, press TUNING + or TUNING â after entering the value close to the frequency you want. The receiver automatically tunes in the station you want. If the frequency seems to be higher than the entered value, press TUNING +, and if the frequency seems to be lower than the entered value, press TUNING â. â¢ If âSTEREOâ flashes in the display and the FM stereo reception is poor, press FM MODE to change to monaural (MONO). You will not be able to enjoy the stereo effect, but the sound will be less distorted. To return to stereo mode, press FM MODE again.
The tuning scale is:
You can enter a frequency of the station you want directly by using the numeric buttons on the supplied remote. For details on the buttons used in this section, see pages 37 â 43 for remote RM-PP411 and pages 44 â 47 for remote RM-U306.
1 Press TUNER on the remote.
The last received station is tuned in.
FM : 100 kHz AM : 10 kHz* * The AM tuning scale can be changed (page 52).
2 Press FM or AM to select the FM or AM
3 Press D. TUNING on the remote. 4 Press the numeric buttons to enter the
Example 1: FM 102.50 MHz
Example 2: AM 1350 kHz
(You donât have to enter the last â0â when the tuning scale is set to 10 kHz.)
If you cannot tune in a station and the entered numbers flash
Make sure youâve entered the right frequency. If not, repeat steps 3 and 4. If the entered numbers still flash, the frequency is not used in your area.
5 If youâve tuned in an AM station, adjust
the direction of the AM loop antenna for optimum reception.
6 Repeat steps 2 to 5 to receive another