|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Yes thank you i got the file i was after. There was a slight problem in my communication but it all worked out well.
A job well done.
;
Great manual...really saved me. The only problem is that I thought I would be able to download it directly when I paid for it but never received the download instructions until the next morning. The board trace pages were somewhat light also: really need to turn up the contrast on the printer before printing them. The schematic page was great; very clear! Well worth the money.
;
I've been in the electronic business for a long time. I used to buy Sam's Photofact for my needs which intailed having to go to the store and paying about $20 for a package of 3 different units so I was forced to buy more than I needed just to get one.
Owner manual is just at your keyboard and the information is almost instantansouly and the cost is very reasonable. Easy to print out if needed or simply read off of the screen. The larger the screen the better for obvious reasons.
;
Very good manual, at a very good price. Received in a timely manner
;
Only thу cover has poor quality, internal material has excellent quality - exactly what I needed
Thanks!
9. Adjust each top and bottom pins by two wedges and then not swing DY neck right and left. (When fixing DY with wedges, insert wedges completely so that the DY does not shake.)
a c b d
13. If using the magnet, be sure to demagnetize with the degausser and check. 14. Remove the sensor and wobbling coil. 15. Fix the purity magnet paisted on the DY with the white pen.Fix it with the RTV.
"a" and "b" must be equal. 10. Adjust the top and bottom pins with the TB.PIN VR complettely. And ajust the V.Size simulation. 11. Adjust the V.key (=H.Trapxoid) with the H-Trp VR so that [a] become equol to the [b]
� Convergence Rough Adjustment
1. Enter the white crosshatch signal (white lines on black). 2. Adjust roughly the horizontal and vertical convergence at four-pole magnet. 3. Adjust roughly HMC and VMC at six-pole magnet.
� Convergence Adjustment
c d
12. If the corner is not within the standards, adjust disc magnet to satisfy L/D adjustment standards. Note: (1) When necessary to paste magnets more than 2 pieces, be careful that the convergence and the distortion would be alterable. (2) Paste within 80 to 120 mm from the DY on the diagonal line of the magnet.
< Static convergence > 1. Change the "CONV SW" to 0. 2. Receive the crosshatch of R and B. (on black) 3. Adjust H. STAT and V. STAT with 4 pole magnet. 4. Recieve the white crosshatch signal.(White line on black) 5. Adjust HMC and VMC with the 6 pole magnet. 6. Recieve the crosshatch of R and B. (on black) Note: Adjust H. STAT and V. STAT in the beggining by 4 pole magnet not adjust them by register immediately.
HMD-A440(E)
3-2
$4.99 HMDA440 SONY Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|