|
Who's Online
There currently are 6007 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Good site, works ok and you get what you order, no problems experienced, got my manual within a day. A++++
;
Original well scanned manual. Got the job done. Microwave problem found & corrected. For $5 and a new magnitron from ebay, it was a cheap and good the first shot fix. Electrical schematics allowed me to mage sure every thing else was ok before cutting and order for parts. Hard to live without.
;
I was very skeptical of this website, I have never downloaded manuals before. I put it on the AMEX and payed through Paypal to ensure protection. I got the manual exactly as described and now I can replace the filter capacitor for this amp. Great Price, others selling for 12.99 or more and this is the same manual. I will search out this website for other manuals. Thank you
;
Manual was reasonably easy to follow. I am not an engineer or know much about electronics but with the manuals help I was able to figure out the problem, identify the part required for the repair. Replacement part cost around $30. Whilst replacing the part I was telling myself, "this aint gonna work cos it seems far too easy". Took about 15 minutes to do and my plasma TV works a treat. Would never have been able to do this without the service manual.
;
It is OK, this manual help me to repair my dynacord
2-3. Installation and Removal of Boards
2-3. Installation and Removal of Boards
2-3-1. CP-137 Board
1. Remove the top plate. (Refer to the section 2-2-1.) 2. Disconnect the seven connectors (CN11, CN12, CN13, CN14, CN15, CN16 and CN22). 3. Disconnect the five flexible card wires (CN3, CN4, CN5, CN6 and CN6a). 4. Remove the five screws on the CP-137 board and two hexagon head screws for D-sub connector. 5. Disconnect the two connectors (CN9 and CN10) and two flexible card wires (CN1 and CN2) while raising the CP-137 board, then remove the CP-137 board.
2-3-2. VR-84 Board
1. Remove the top plate. (Refer to the section 2-2-1.) 2. Remove the front panel. (Refer to the section 2-2-2.) 3. Remove the three screws, then remove the VR-84 board from the front panel.
Front panel
BV3 x 8 VR-84 board BV3 x 8
PSW3 x 6 CN1 CN2 PSW3 x 6 CN6a CN10 CN9 BV3 x 8
4. Install the VR-84 board in the reverse order of steps 1 through 3.
CN22
CN6 to CN3
CN16 to CN11
2-3-3. MS-26 Board
1. Remove the top plate. (Refer to the section 2-2-1.) 2. Remove the front panel. (Refer to the section 2-2-2.) 3. Remove the VR-84 board. (Refer to the section 2-32.) 4. Remove the four screws, then remove the MS-26 board from the front panel.
CP-137 board D-sub connector Hexagon head screw
6. Install the CP-137 board in the reverse order of steps 1 through 5.
Front panel
Memory key MS-26 board BV3 x 8
5. Install the MS-26 board in the reverse order of steps 1 through 4.
2-2
HKDV-503E
|
|
|
> |
|