|
Who's Online
There currently are 5865 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Exactly what was needed to assess the product - excellent value and great service
;
Nice to have the service manual for the Sony DCR-TRV345E now. The document is of excellent quality.
;
MACKIE HR824 26 pages English-only Service Manual contains:
1) HR824 technical overview with the description of front and rear panel switches.
2) HR824 specs
3) Block Diagram
4) Wiring Diagram
5) Packaging management
6) Spare part & final assembly list (for PCB rev A and B) + exploded view
7) Test Procedures (where, how to measure voltage...) including Test Point diagram on the PCB.
8) IC and Transistor charts.
Excellent guide: very clear, good scan quality enabling us to print readable diagram :-)
Note:
Mackie HR824 make extensive use of surface mount devices (SMD). Service on the HR824 must
only be undertaken by experienced service technicians with the right tools, experience and patience to perform surface mount rework when needed.
;
This Service manual is very well scanned and its clean to read, no any anti-theft words that un-english could understand. I got my CCD600 working with this manual and it´s clear shematics :)
;
I was very pleased with the service provided and was surprised at how good the quality was of the manual. I thought it may be a third generation copy or so, but it is as good as the websites that charge 3 times this much. I repair some electronics for family and friends without charge, so this is perfect for me. Thank you very much.
3-2. Replacing the Filter Disk Unit
4. Adjust the indication (ND, CC) of the filter knob to coincide with respective ND, CC of the new filter disk unit, respectively as shown below. 5. Pulling the filter knob (CC) to the arrow direction, then install the new filter disk unit in the camera. n At installation, do not touch the surfaces of filters.
Filter knob (CC)
7. Be sure that ND of the filter disk unit is correspondingly linked to the filter knob (ND) and do CC to (CC) in the same fashion by means of turning the filter knob (ND, CC). 8. Fix the filter disk unit using two screws, then connect a connector. n There is an occasion need to tune up a balance for torque of the filter knob (ND, CC) when a replacement of a filter disk unit is performed. In this case loosen two screws first, then make the knob have 1 or 2 turns for adjusting torque. After making sure of the right torque, tighten the screws again.
Loosen each screw
FilterMOTORunit disk
ON OFF
ND
1
B
1
1 CLEAR 2 1/4 ND 3 1/8 ND 4 1/16ND 5 1/64ND
CC B
A CROSS B CLEAR C 4300K D 6300K E 8000K
6. Little by little turning the filter knob (ND, CC) to left or right direction, have knob (ND, CC) and the filter disk unit ND, CC to be coincided properly.
HDC-900/950 MM
3-3 (E)
|
|
|
> |
|