This is a good quality scan of the original Service Manual from Nordmende, Germany. Contains the circuit diagram, PCB layout, adjust/tune instructions as well. It is NOT in English but in GERMAN language! That was quite right for my german friend from the lower east side in Berlin.
Received via e-mail this PDF manual is worth the money. This is a quality scan of a manual in excellent condition and is just as good as having the original manual in hand. I have later seen the original manual and it was printed in colour, but this particular manual is black & white but scan resolution is high end quality! All drawings and pictures are presented in great detail. So, nearly perfect score in my opinion.
If you own the turntable you also should own the manual!
Great product. Recieved it fast...exactly as advertised.
Text excerpt from page 29 (click to view)
2-11. Replacement of Fan
2-11. Replacement of Fan
c If the fan is out of order, the inside temperature of the unit will rise. Touching the inside in this state may cause a burn. When replacing the fan, allow a few minute after powering off until the inside cools off. 1. Perform the procedures 1 to 3 in Section 2-7-2 to remove the CCD unit. 2. Remove the seven screws to remove the V shoe bracket.
4. Remove the four screws to remove the fan.
Fan
B2.6 x 20
Harness
B2.6 x 20 Label
Bracket
5. Install a new fan in the reverse order of removal.
B3 x 5
[Notes|at|installation] . Install the fan to the bracket with care so that the label faces the bracket and the fan harness is routed as shown in the above figure. . Insure a proper fit between the fan bracket and chassis as shown in the figure below.
Fan bracket
V shoe bracket
K3 x 8 B3 x 5
3. Remove the two screws. Disconnect the harness from the SW-688 board.