|
Who's Online
There currently are 5898 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Everything was great, the manual, the response time, the simplicity of the order, and the
Price. The only thing that I could possible say on a negative note would be that the manual I ordered was more for a service tech. There were a lot of schematic diagrams that didn't help me solve the problem. However I would order again and recommend the web sight to others.
;
I'd been looking for this manual for awhile. Exactly what I needed - and at an excellant price. Thanks!
;
very complete. acceptable resolution. details are a little unclear. is a manual note 8.
;
excellent service - fast purchase - easy download - will buy from again
;
Manual is actually a pack of schematics, good quality pictures.
HCD-GSX75
SECTION 5 MECHANICAL ADJUSTMENTS
SECTION 6 ELECTRICAL ADJUSTMENTS
DECK SECTION
0 dB = 0.775 V
� TAPE MECHANISM DECK SECTION
Precaution 1. Clean the following parts with a denatured alcohol-moistened swab: record/playback heads pinch rollers erase head rubber belts capstan idlers 2. Demagnetize the record/playback head with a head demagnetizer. 3. Do not use a magnetized screwdriver for the adjustments. 4. After the adjustments, apply suitable locking compound to the parts adjusted. 5. The adjustments should be performed with the rated power supply voltage unless otherwise noted. Torque Measurement
Mode Torque meter Meter reading
Precaution 1. Demagnetize the record/playback head with a head demagnetizer. 2. Do not use a magnetized screwdriver for the adjustments. 3. After the adjustments, apply suitable locking compound to the parts adjust. 4. The adjustments should be performed with the rated power supply voltage unless otherwise noted. 5. The adjustments should be performed in the order given in this service manual. (As a general rule, playback circuit adjustment should be completed before performing recording circuit adjustment.) 6. The adjustments should be performed for both L-CH and RCH. 7. Switches and controls should be set as follows unless otherwise specified. � Test Tape
Tape P-4-A100 WS-48B Signal 10 kHz, � 10 dB 3 kHz, 0 dB Used for Azimuth Adjustment Tape Speed Check
FWD FWD /REV back tension
CQ-102C CQ-102C
2.44 mN � m to 8.33 mN � m 30 to 85 g � cm (0.42 � 1.17 oz � inch) 0.14 mN � m to 0.59 mN � m 2 to 6 g � cm (0.03 � 0.08 oz � inch) 2.94 mN � m to 7.84 mN � m 31 to 71 g � cm (0.43 � 0.98 oz � inch) 6.86 mN � m to 20.6 mN � m 71 to 210 g � cm (0.98 � 2.91 oz � inch)
REV
CQ-102RC
FF/REW
CQ-201B
18
|
|
|
> |
|