|
Who's Online
There currently are 5488 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
;
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
;
The manual is of better quality compared to other. I found it less expensive and therefore it it is the best buy cost vs quality.
;
I bought the service-manual of the sony ICB-1020(an old transmitter-receiver) at "www.Owners-Manual.com", I found the service-manual for a fairly cheap price(in comparison with other sellers). I filled in some questions, payed the order with Ideal, and within 24 hours I had my service manual. I was very happy:In no time I had my service-manual and everything, but literally everything was noted down in the manual; the electronic scheme, the parts list, etcetera.
A very practical, reference-document.
;
This comprehesive service maual was greatly appreciated, as was the digital download.
5-2-2. Density Adjustment
n Before replacing the thermal head, print a test pattern (STEP) with the old head (defective head) or in the normal condition to be used as a reference of density level. 1. Start the unit with the AC adaptor to enter the service mode. (Refer to Section 5-1.) n Never use the battery to start the unit. In case of starting the unit with the battery, �BAT V� is displayed instead of �AC�. Do not press the ENTER key at that time. Otherwise, a malfunction may occur in the battery voltage detection. (The remaining battery amount cannot be detected correctly.) 2. Enter the TESTP menu, then select �STEP� using the _ key or + key and press the ENTER key. A density adjustment pattern (STEP) is printed. This is used as a reference of the density adjustment. 3. Turn off the power. 4. Replace the thermal head. (Refer to Section 1-4-3.) 5. Turn on the power, then print a test pattern (STEP) again. 6. Adjust the density so that the test pattern is the same in level as the reference test pattern printed before replacing the head. To adjust the density, enter the SET-2 menu, then select �STBWI� using the _ key or + key and press the ENTER key. . To increase the density: Press the + key to increase the value and press the ENTER key. . To decrease the density: Press the _ key to decrease the value and press the ENTER key. n The value cannot be selected if the ENTER key is not pressed after changing the value.
<Example of screen>
170
STBWI
7. Repeat steps 5 and 6 until the test pattern equivalent to the reference in density level is obtained. n The value has the upper limit. If a value exceeding the upper limit is set, it will be impossible to make the full use of the capabilities of the printer. For the upper limit of the set value, refer to the technical memo.
DPP-MP1 (UC, CE)
5-9
$4.99 DPPMP1 SONY Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|