|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Il service manual molto accurato. Rapidi nella risposta
;
Quick site processing. A complete and very useful manual with all details. Thank you!
;
Quick service response. A useful and very rare service manual with all details. I recomend this service.
;
I ordered this manual sometime in the afternoon and I received it on my e-mail the same evening.
This is a fantastically good and properly scanned copy of the original manual. All pages are of the same scale and they overlap each other. It means that you can print the manual and easily make it as a convenient paper manual.
The content of the manual is fantastic. Alignment descriptions, PCB layouts and elementary diagrams are explicit and precise. I immediately found what I was looking for. Thanks to this manual and Owner-Manuals.com my amplifier is alive again. Many thanx indded!
;
The manual was well-scanned and easy to read. As an added bonus, the Operator's Manual was bundled with the Service Manual!
I'd definitely use owner-manuals.com again.
DCR-PC330/PC330E
COVER
1-1. SERVICE NOTE
1. POWER SUPPLY DURING REPAIRS
SECTION 1 SERVICE NOTE
In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4V), the power is shut off so that the unit cannot operate. This following two methods are available to prevent this. Take note of which to use during repairs. Method 1. Use the AC power adaptor (AC-L15, AC-VQ800 etc.). Method 2. Connect the servicing remote commander RM-95 (J-6082-053-B) to the LANC jack, and set the commander switch to the �ADJ� side.
2.
1 2 3 4 5 6 7 8 9 q; qa
TO TAKE OUT A CASSETTE WHEN NOT EJECT (FORCE EJECT)
Open the flash. (When the flash doesn�t open, refer to �3. HOW TO OPEN THE FLASH WHEN THE FLASH DOSEN�T OPEN�.) Refer to page 2-3 to remove the cabinet (F) section. Refer to page 2-3 to remove the cabinet (Rear) section. Refer to page2-4 to remove the cabinet (R) section. Refer to page2-11 to remove the EVF section. Refer to page2-13 to remove the stroboscope section. Refer to page2-15 to remove the lens section. Open the VC-325 board. Refer to page 2-19 to remove the VC-325 board and the mechanism deck. Disconnect CN2502 (27P, 0.3mm) of VC-325 board. Supply +4.5V from the DC power supply to the loading motor and unload with a pressing the cassette compartment.
Loading motor DC power supply (+ 4.5Vdc)
Disconnect the flexible board from CN2502 of VC-325 board.
CN2502
VC-325 board
3.
HOW TO OPEN THE FLASH WHEN THE FLASH DOSEN�T OPEN
1-1
|
|
|
> |
|