|
Who's Online
There currently are 5745 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I am a vintage hifi collector. No way to fix that device without the appropriate service manual...thanks to your site I got it and every thing is easier now. I got the manual right after ordering: fast cheap accurate ... thank you
;
Wonderful job clear. Qick fantastic. These people are really good. If even a problem arise they are wonderful assisting you. These scheme is so net despite this is a very old TV. Thank you for everything!!!!!!!!
;
Detailed schematic diagram, manual for professionals
;
Good service manual,exploded view,adjusment and test point locations,head alignment,mechanical checks and adjusments,all perfect.
;
Block diagram,play rec block diagram,adjusments, it's a very good well done repair manual.
DCR-IP210/IP210E/IP220/IP220E
3.
DISCHARGING OF THE FLASHLIGHT POWER SUPPLY CAPACITOR
The capacitor (ST-076 board C4208) of the flash unit is charged up to the maximum 300V potential. There is a danger of electric shock by this high voltage when the ST-076 board is handled by hand. The electric shock is caused by the charged voltage which is kept without discharging when the main power of the unit is simply turned off. Therefore, the remaining voltage must be discharged as described below. 3-1. PREPARING THE SHORT JIG To preparing the short jig. a small clip is attached to each end of a resistor of 1k� /1W (1-215-869-11). Wrap insulating tape fully around the reads of the resistor to prevent electric shock.
1 k �/1 W
Wrap insulating tape
3-2. DISCHARGING THE CAPACITOR 1 Remove the power supply (Battery or AC power adaptor). 2 Refer to 2-3. and 2-4. to remove the cabinet (F) assembly. 3 Short-circuit between TP4201 of the ST-076 board and the LND421 (GND) with the short jig about 10 seconds.
Short jig 1k�/1W resister
TR4201
C4208
LND421
ST-076 board
4.
HOW TO OPEN THE FLASH WHEN THE FLASH DOESN�T OPEN
1 Remove the power supply (Battery or AC power adaptor). 2 Refer to 2-2. to remove the front cap assembly. 3 Press the Stopper in the direction of the arrow using a rod.
Stopper
5.
COAXIAL CONNECTOR OF THE BLUETOOTH HARNESS (DCR-IP220/IP220E model)
When the coaxial connector of the Bluetooth harness isn�t pulled out vertically toward the board, the connector may be damaged. So, when disconnecting the connector, be sure to take the connector of the Bluetooth harness, and pull iPress the Stopper in the direction of the arrow using a rod/t out vertically toward the board.
Connector of the Bluetooth harness Bluetooth harness
1-2
|
|
|
> |
|