I must admit, I was very skeptical... $4.99 for a 74 page service manual. I've seen some very poorly scanned manuals on the Internet, but this one is VERY good quality! Even when zooming into 500%. Great Deal!
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
Text excerpt from page 22 (click to view)
HCD-C770/C990
Ver 1.5
4-3.
HOW TO INSTALL THE GEAR (MODE 2)
1 Align the mark on the rotary encoder (S701) with the projection of the assy. 2 Check that the cam (BU U/D) can not be rotated in the direction of arrow. 3 Install the gear (mode 2).
rotary encoder (S701) gear (mode 2)
cam (BU U/D)
mark
projection � bottom view � front �
chassis
4-4.
HOW TO INSTALL THE GEAR (MODE CAM)
1 Slide the shaft in the direction of arrow. 2 Align mark A on the gear (mode cam) with mark B on the slider (mode cam) assy, then install the gear (mode cam). 3 Check that mark C on the gear (mode cam) is in alignment with mark D on the cam (gear).