perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Super nice! Good to have a manual in digital format.
Text excerpt from page 28 (click to view)
â¢ R. H. LOW Select this if the rear speakers are located in the section D. â¢ R. H. HIGH Select this if the rear speakers are located in the section C. These parameters are not available when âREARâ is set to âNOâ. To specify the balance and level of the speakers
1 2 3
Press AMP MENU repeatedly to display 9 LEVEL on the front panel display. Using X/x to select T.TONE and use C/c to set T.TONE to ON. You will hear the test tone from each speaker in sequence. Sit in your listening position and select the item to be adjusted using X/x. â¢ Items adjusted in 9 LEVEL â Balance of the front and rear speakers â Volume level of the centre and rear speakers and subwoofer Adjust the volume level so that the volume of the test tone from each speaker sounds the same using C/c. The adjusted value will appear on the front panel display. Repeat Steps 3 and 4 to adjust other parameters in 9 LEVEL. If you do not operate the remote for a few seconds, the value disappears from the display and is stored in the system. Using X/x to select T.TONE and use C/c to set T.TONE to OFF.
4 5 6
xBALANCE You can vary the balance of each speaker as follows. The default adjustments are in the parentheses. â¢ F ___I___ (centre) (front speakers) Adjust the balance between the front left and right speakers (You can adjust from centre, 6 steps left or right). â¢ R ___I___ (centre) (rear speakers) Adjust the balance between the rear left and right speakers (You can adjust from centre, 6 steps left or right).