This manual was very clear and complete, the prices can't be beat, great to have older manuals available!
Text excerpt from page 17 (click to view)
D2846
2-9. PICTURE TUBE REMOVAL
1
Open the D block (Refer 2-2.)
6
Four screws (+ BVTT 4 x 8)
4
Three connectors GND (DY) 6P (DY) 10P (DY)
3
A board
5
Anode cap
2 8 9
Neck assy
Open the G block (Refer 2-3.)
Deflection yoke
7
Picture tube
� REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after removing the anode.
� REMOVING PROCEDURES
c
b
a
Anode Button
1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.
� HOW TO HANDLE AN ANODE-CAP
1 Don�t hurt the surface of anode-caps with shartp shaped material! 2 Don�t press the rubber hardly not to hurt inside of anode-caps! A material fitting called as shatter-hook terminal is built in the rubber. 3 Don�t turn the foot of rubber over hardly! The shatter-hook terminal will stick out or hurt the rubber.
3 When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling up it in the direction of the arrow c.
