Manual was just as described!!! I odered it and in less than a day was able to download it and the text was clear and pages were all complete just as the original manual was. Purcashed this for a friend and they were more than happy. Perfect all around!
The manual I purchased was exactly what I needed to repair my Toshica television. The manual contained schematics and troubleshooting information that was very helpful.
The Service Manual was just as expected, complete with schematics and I was able to download it in less than an hour after I ordered it. The only problem with these is that the schematics are hard to read due to the small font. I could remedy this by printing them on a larger printer.
Text excerpt from page 23 (click to view)
CX-BK1
4-5.
HOW TO INSTALL THE ROTARY ENCODER (S702), GEAR (STOCKER COMMUNICATION)
4 gear (stocker communication) 3 screw (PWH2 � 6) 5 screw (PTPWH2.6 � 8)
7 two screws (PTPWH2.6 � 8)
Engage the rotary encoder (S702) and the gear (stocker communication) as shown below in the figure. rotary encoder (S702)
1 rotary encoder (S702)
6 two gears (stocker communication)
2 five solders
gear (stocker communication)
CONNECTOR board
� rear �
4-6.
HOW TO INSTALL THE STOCKER ASSY
3 screw (PTPWH2.6 � 8) 2 cam (stocker V)
boss
Install the stocker assy fitting three bosses into the each groove of cam then fix by rotating the cams in the direction of arrow.
boss
5 two screws (PTPWH2.6 � 8) 4 two cams (stocker U/D)
cam
To install three cams, align each groove of the cam with each f mark on the chassis as shown in the figure.
rotary encoder (S702)
screw
hole
1 Position the hole on the gear (stocker communication) on the screw of the rotary encoder (S702).