Very very good as usual very trustable site. Perfect!!!!!!
Text excerpt from page 13 (click to view)
2-4. PICTURE TUBE REMOVAL
â¢ Remove the D, A and J boards (Refer to 2-3.)
2 Neck assy
3 Deflection yoke 4 Four screws
(Tapping screw 5)
5 Picture tube shield
1 Anode cup
6 Picture tube
â¢ REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after removing the anode.
â¢ REMOVING PROCEDURES
1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.
â¢ HOW TO HANDLE AN ANODE-CAP
1 Donât hurt the surface of anode-caps with shartp shaped material! 2 Donât press the rubber hardly not to hurt inside of anode-caps! A material fitting called as shatter-hook terminal is built in the rubber. 3 Donât turn the foot of rubber over hardly! The shatter-hook terminal will stick out or hurt the rubber.
3 When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling up it in the direction of the arrow c.