Dear Sirs,
Thank you for the fast support, the manual does provide all necessary information to repair the radio. All schematics are in a good quality for reading.
The manual fits 100% to my requirements as a technican.
Kind regards Thomas
the big video recorder format s-vhs many features delicate in loading system of the cassette. Such machines are no longer manufactured, it would be too expensive.
THIS MANUAL IS VERY GOOD AND VERY CLEAR
PLEASE NOTE IT DOES NOT CONTAIN THE SETUP INFORMATION TO ALIGHN THE GEARS IN THE CD MECH IT DOES SHOW ALL THE PARTS AND THEIR LOCATIONS .
Complete service and operation manual. All schematics are there, all circuit boards AND add-on boards. Including exploded views ,component names and specifications. Also electrical and mechanical adjustment procedures are in this manual. This manual also covers the more advanced BR-S811E unit. Scan quality is fair and usable.
High quality scan of original Service Manual. Everything´s fine!
Text excerpt from page 13 (click to view)
SECTION 6 DIAGRAMS
6-1. CIRCUIT BOARDS LOCATION THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS. (In addition to this necessary note is printed in each block.)
For schematic diagrams. Note:
� All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or less are not indicated except for electrolytics and tantalums. � All resistors are in � and 1 /4 W or less unless otherwise specified. � % : indicates tolerance. � ¢ : internal component. � 2 : nonflammable resistor. � 1 : fusible resistor. � C : panel designation. Note: The components identified by mark ! or dotted line with mark ! are critical for safety. Replace only with part number specified. � � � � � U : B+ Line. V : B� Line. H : adjustment for repair. Voltages and waveforms are dc with respect to ground under no-signal (detuned) conditions. Voltages are taken with a VOM (Input impedance 10 M�). Voltage variations may be noted due to normal production tolerances. Waveforms are taken with a oscilloscope. Circled numbers refer to waveforms. Signal path. J : CD c : DIGITAL OUT
45MHz 16.9344MHz (PLAY)
� Waveform
1
TP1 (RF)
1.5Vp-p
KEY board POWER SW board SERVO board
2
CN304 !¡
2.7Vp-p
3
IC301%¢ (128FSO)
4.0Vp-p
HP board
5.6448MHz (128Fs)
ROTARY SW board MAIN board DISP board
� � �
4
IC301@� (XOUT)
4.8Vp-p
For printed wiring boards. Note:
� X : parts extracted from the component side. � ® : Through hole. � ¢ : internal component. � b : Pattern from the side which enables seeing.